Gefen EXT-IP-2-RS2322 user manual #settcpbrport

Page 39

Advanced Operation

Commands

#set_tcp_br_port

Sets the TCP bridge listening port for the specified serial port. The default port settings for RS-232 1 and RS-232 2 ports are 49200 and 49201, respectively.

Syntax

#set_tcp_br_port param1 param2

Parameters

param1

Serial port

[1

... 2]

param2

TCP port

[1

... 65535]

Example

#set_tcp_br_port 1 49200

TCP Bridge 1, port set to: 49200

Related Commands

#set_tcp_term_port #set_udp_br_port

page 29

Page 38 Page 40
Image 39
Page 38 Page 40
Contents
IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Web site Operating NotesFeatures and Packing List FeaturesPacking List Vii Table of Contents Page Page Getting Started Introduction IP to 2xRS-232 ConverterIntroduction Installation Sample Wiring DiagramConnection Instructions Page Page Advanced Operation Configuration using the Gefen Discovery Tool RS-232 and IP ConfigurationDiagram 2.1 Configuration using a null-modem cable Configuration using RS-232Information Commands Commands Example #helpAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata Param1 Value #systemwidereset#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Using the built-in Web Interface Web InterfaceHelp Description RS-232 ModeRS-232 Select RS-232 PortStop Bits Baud RateData Bits ParityLine Delay ms Force Send msForce Send bytes Use End Delimiter Add Delimiters to data sentUse Start Delimiter Start Delimiter ValueEnd Delimiter Value TCP PortUDP Local Port UDP Echo Set DefaultsDestination IP Destination PortIP Address Network tabMAC Address ModeHttp Port GatewayUser Name Enable TCP AccessRequire Password on Connect Old PasswordNew Password Confirm PasswordTerminal Port Enable UDP Access Enable UDP EchoUDP Port Enable Discovery Destination UDP IP AddressDestination UDP Port System tab Download Download Current ConfigurationBrowse... Restore Configuration RestoreReset Browse... Firmware UpdateUpdate Factory ResetPage Appendix RS-232 Settings Default SettingsNetwork IP SettingsConnectors, Indicators, and Controls RS-232 SpecificationsPage Nordhoff St., Chatsworth CA
Top Page Image Contents