Gefen EXT-IP-2-RS2322 user manual Browse... Firmware Update, Factory Reset, Reboot

Page 77

Advanced Operation

Web Interface

Browse... (Firmware Update)

Click this button to select the firmware file to be uploaded.

Update

Click this button to upload the selected firmware file. See the Browse... button, above.

Factory Reset

Use these check boxes to select the type of factory-reset to perform. Placing a check mark in the desired check box will select the type of reset:

Options: Select All (resets network and RS-232 settings),

Network (resets IP settings only), RS-232 (resets RS-232 settings only)

Reset

Click this button to reset the selected options to factory-default settings.

Reboot

Click this button to reboot the IP to 2 x RS-232 Converter.

page 67

Image 77

Contents

IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Web site Operating NotesPacking List Features and Packing ListFeatures Vii Table of Contents Page Page Getting Started Introduction IP to 2xRS-232 ConverterIntroduction Connection Instructions InstallationSample Wiring Diagram Page Page Advanced Operation Configuration using the Gefen Discovery Tool RS-232 and IP ConfigurationDiagram 2.1 Configuration using a null-modem cable Configuration using RS-232Information Commands Commands Example #helpAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata Param1 Value #systemwidereset#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Help Using the built-in Web InterfaceWeb Interface RS-232 RS-232 ModeSelect RS-232 Port DescriptionData Bits Baud RateParity Stop BitsForce Send bytes Line Delay msForce Send ms Use Start Delimiter Add Delimiters to data sentStart Delimiter Value Use End DelimiterUDP Local Port End Delimiter ValueTCP Port Destination IP Set DefaultsDestination Port UDP EchoMAC Address Network tabMode IP AddressHttp Port GatewayRequire Password on Connect Enable TCP AccessOld Password User Name Terminal Port New Password Confirm Password UDP Port Enable UDP AccessEnable UDP Echo Destination UDP Port Enable DiscoveryDestination UDP IP Address Browse... Restore Configuration Download Download Current ConfigurationRestore System tabUpdate Browse... Firmware UpdateFactory Reset ResetPage Appendix RS-232 Settings Default SettingsNetwork IP SettingsConnectors, Indicators, and Controls RS-232 SpecificationsPage Nordhoff St., Chatsworth CA