Gefen EXT-IP-2-RS2322 user manual #systemwidereset, Param1 Value

Page 57

Advanced Operation

Commands

#system_wide_reset

Restarts the IP to 2 x RS-232 Converter according to the supplied parameter.

Syntax

#system_wide_reset param1

Parameters

param1

Value

[0 ... 3]

Value Description

0Reboot only

1Reset IP settings

2Reset serial port settings

3Reset all and reboot

Example

#system_wide_reset 3

System wide reset in progress. Please wait...

Finish selected operation.

Device will be reset and all connections will be closed.

page 47

Image 57

Contents

IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Web site Operating NotesFeatures and Packing List FeaturesPacking List Vii Table of Contents Page Page Getting Started Introduction IP to 2xRS-232 ConverterIntroduction Installation Sample Wiring DiagramConnection Instructions Page Page Advanced Operation Configuration using the Gefen Discovery Tool RS-232 and IP ConfigurationDiagram 2.1 Configuration using a null-modem cable Configuration using RS-232Information Commands Commands Example #helpAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata Param1 Value #systemwidereset#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Using the built-in Web Interface Web InterfaceHelp RS-232 RS-232 ModeSelect RS-232 Port DescriptionData Bits Baud RateParity Stop BitsLine Delay ms Force Send msForce Send bytes Use Start Delimiter Add Delimiters to data sentStart Delimiter Value Use End DelimiterEnd Delimiter Value TCP PortUDP Local Port Destination IP Set DefaultsDestination Port UDP EchoMAC Address Network tabMode IP AddressHttp Port GatewayRequire Password on Connect Enable TCP AccessOld Password User NameNew Password Confirm PasswordTerminal Port Enable UDP Access Enable UDP EchoUDP Port Enable Discovery Destination UDP IP AddressDestination UDP Port Browse... Restore Configuration Download Download Current ConfigurationRestore System tabUpdate Browse... Firmware UpdateFactory Reset ResetPage Appendix RS-232 Settings Default SettingsNetwork IP SettingsConnectors, Indicators, and Controls RS-232 SpecificationsPage Nordhoff St., Chatsworth CA