Gefen EXT-IP-2-RS2322 user manual #setudpbrport

Page 42

Advanced Operation

Commands

#set_udp_br_port

Sets the UDP bridge listening port. The default UDP bridge port settings for RS-232 1 and RS-232 2 ports are 50200 and 50201, respectively.

Syntax

#set_udp_br_port param1 param2

Parameters

param1	Serial port	[1	... 2]
param2	Port	[1	... 65535]

Example

#set_udp_br_port 1 50200

UDP Bridge 1, port set to: 50200

Related Commands

#set_tcp_br_port #set_tcp_term_port #set_start_del #set_udp_remote_br #set_udp_rip #set_udp_rport

page 32

Image 42

Contents

IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Operating Notes Web siteFeatures and Packing List FeaturesPacking List Vii Table of Contents Page Page Getting Started IP to 2xRS-232 Converter IntroductionIntroduction Installation Sample Wiring DiagramConnection Instructions Page Page Advanced Operation RS-232 and IP Configuration Configuration using the Gefen Discovery ToolConfiguration using RS-232 Diagram 2.1 Configuration using a null-modem cableInformation Commands Commands #help ExampleAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata #systemwidereset Param1 Value#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Using the built-in Web Interface Web InterfaceHelp Select RS-232 Port RS-232 ModeRS-232 DescriptionParity Baud RateData Bits Stop BitsLine Delay ms Force Send msForce Send bytes Start Delimiter Value Add Delimiters to data sentUse Start Delimiter Use End DelimiterEnd Delimiter Value TCP PortUDP Local Port Destination Port Set DefaultsDestination IP UDP EchoMode Network tabMAC Address IP AddressGateway Http PortOld Password Enable TCP AccessRequire Password on Connect User NameNew Password Confirm PasswordTerminal Port Enable UDP Access Enable UDP EchoUDP Port Enable Discovery Destination UDP IP AddressDestination UDP Port Restore Download Download Current ConfigurationBrowse... Restore Configuration System tabFactory Reset Browse... Firmware UpdateUpdate ResetPage Appendix Default Settings RS-232 SettingsIP Settings NetworkSpecifications Connectors, Indicators, and Controls RS-232Page Nordhoff St., Chatsworth CA