Gefen EXT-IP-2-RS2322 user manual Network tab, MAC Address, Mode, IP Address, Subnet

Page 70

 

Web Interface

Advanced Operation

Network tab

 

MAC Address

The MAC address of the IP to RS-232 Converter. The MAC address cannot be changed.

Mode

Select the network mode from the drop-down list.

Options: Static, DHCP

IP Address

Enter the IP address of the IP to 2 x RS-232 Converter.

Range (per byte): 0 ... 255

Subnet

Enter the subnet mask of the IP to 2 x RS-232 Converter.

Range (per byte): 0 ... 255

page 60

Image 70
Contents IP to RS-232 Important Safety Instructions Warranty Information Contacting Gefen Technical Support Operating Notes Web siteFeatures Features and Packing ListPacking List Vii Table of Contents Page Page Getting Started IP to 2xRS-232 Converter IntroductionIntroduction Sample Wiring Diagram InstallationConnection Instructions Page Page Advanced Operation RS-232 and IP Configuration Configuration using the Gefen Discovery ToolConfiguration using RS-232 Diagram 2.1 Configuration using a null-modem cableInformation Commands Commands #help ExampleAdvanced Operation #setadddelim #setdevicedescr #setenddel #setgateway #sethttpport #setipadd #setnetmask #setsendbytecnt #setsendtimeout #setserialdescr #setserialmode #setserialparams Baud Rate = 19200 Bps Line Delay = 1000 ms #setstartdel #settcpbrport #settcptermport #settelnetpass #setudpbrport #setudpechobr #setudpport #setudpremotebr #setudprip #setudprport #showdelprms #showdevicedescr #showipconfig #showme #showserialdescr #showserialmode #showserialparams #showtelnetpass #showverdata #systemwidereset Param1 Value#usediscovery #usetcpaccess #usetcptermpass #useudpaccess #useudpecho Web Interface Using the built-in Web InterfaceHelp Select RS-232 Port RS-232 ModeRS-232 DescriptionParity Baud RateData Bits Stop BitsForce Send ms Line Delay msForce Send bytes Start Delimiter Value Add Delimiters to data sentUse Start Delimiter Use End DelimiterTCP Port End Delimiter ValueUDP Local Port Destination Port Set DefaultsDestination IP UDP EchoMode Network tabMAC Address IP AddressGateway Http PortOld Password Enable TCP AccessRequire Password on Connect User NameConfirm Password New PasswordTerminal Port Enable UDP Echo Enable UDP AccessUDP Port Destination UDP IP Address Enable DiscoveryDestination UDP Port Restore Download Download Current ConfigurationBrowse... Restore Configuration System tabFactory Reset Browse... Firmware UpdateUpdate ResetPage Appendix Default Settings RS-232 SettingsIP Settings NetworkSpecifications Connectors, Indicators, and Controls RS-232Page Nordhoff St., Chatsworth CA