Korg D8 manual Saving a song on a removable disk drive Backup

Page 38

3Insert another disk into the removable disk drive.

If you insert an uninitialized disk, the display will read “Init→ ✽?” (✽ is the SCSI ID A-G of the drive), asking whether you wish to initialize the disk. If

you wish to initialize, press and hold the [] key for approximately one second to initialize the disk. (Refer to “3. Initializing and formatting a drive”)

■Exchanging disks on a removable disk drive which is not currently selected

If the currently selected song is on a drive other than the removable disk drive, use the following procedure to exchange disks.

✧Press the Eject key of the external removable disk drive to remove the disk, and insert a different disk. (For the location of the Eject key, refer to the owner’s manual for your removable disk drive.)

If the disk is unformatted, refer to “3. Initializing and formatting an external drive”.

5.Saving a song on a removable disk drive (Backup)

There are two ways in which a song can be saved on an external disk: Song Copy and Backup. Song Copy and Backup differ in the following ways.

Song Copy

Backup

The song can be selected

The song cannot be

and played

selected (you must

 

Restore before the song

 

can be selected)

 

 

The save destination song

The song is always over-

number can be specified

written, and the song

 

number cannot be speci-

 

fied

 

 

Song data extending over

Song data extending over

multiple disks cannot be

multiple disks can be

saved

saved

 

 

A hard disk drive or remov-

A removable disk drive or

able disk drive can be

DAT can be used

used

 

 

 

If you wish to save a song by copying it to an exter- nal hard disk drive or removable disk drive, refer to “Copying a song” (p.35).

This section will explain how to backup a song to a removable disk drive. For the procedure of backing up to a DAT recorder, refer to “1. Saving a song to a DAT recorder (Backup)” (p.43).

Korg will accept no responsibility for any loss of data which may result from failure to backup/ restore correctly.

■Backing up a song to a removable disk drive

1Press the [EDIT] key, and then press the [SONG TRACK] key several times to display the song name (EDIT SONG/TRACK P1).

A01:SngNaú

EDIT

SONG /

TRACK

 

E

2Press the [ ] key, and then rotate the [VALUE] dial to select the drive which contains the song that you wish to backup. If you are backing up an indi- vidual song, press the [ ] key and then rotate the [VALUE] dial to select the song number as well.

3Press the [SYSTEM] key several times to make the display read “DiskUtil”.

DiskUtil Ï

4Press the [ ] key, and then press the [SYSTEM] key several times to make the display read “Backup”.

Backup ú

EDITSYSTEM

E

5Press the [ ] key. The drive and song number that you selected in step 2 will be displayed. If you wish to backup all songs in the currently selected drive, rotate the [VALUE] dial to select 1-✽✽(All). If you wish to backup an individual song, leave this setting unchanged.

6Press the [ ] key, and then rotate the [VALUE] dial to specify the backup destination drive (A–G).

¿B:RM 100Ï

7Press the [ ] key, and the display will indicate the number of disks that you will need. Prepare the appropriate number of disks of the same capacity as the disk that is currently in the drive.

¿x02DisksÏ

8Press the [ ] key, and the contents of the backup will be displayed. Press the [ ] key. The display will indicate “Over Wrtok?”, asking you to confirm that you wish to overwrite the backup destination disk. If you wish to execute the backup operation, press and hold the [ ] key for approximately one second.

I**¿B**ok?

Chapter 2

Operation

 

 

Saving to and load- ing from

DAT

41

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Page Table of Contents Synchronization and control with a Midi Adjusting and storing mixer settingsMoving and storing time locations Saving to and loading from DATOperation Connections to your audio system etc Power on/offConnections, Power-on, Demo Listening to the demo songs Turning the power onTurning the power off 01ScukyllCreating and selecting songs Creating a new songNaming a song 03KORG1 Connecting the input device and adjusting the levelRecording analog record- ing Starting and stopping recordingRecording digital recording Using EQ to modify the tone as you recordAdjusting the EQ BackEditing the effect Selecting the location at which the effect will be insertedSelecting the effect program Saving the effect programSending the input sound to the effect Master Send TypeEditing the monitor delay Applying the dedicated delay to the input soundTurning the monitor delay on/off MonAuto Select the playback/recording tracksSelect the input monitor Redo Auto Punch In/OutUndo Storing the in and OUT timesRehearsing auto punch in/out Auto punch in/out settingPstRol02M Playback track and recording track settings Combining multiple tracks into one or two tracks BounceAdjusting the playback level and recording level Applying EQ and effects while you recordListening to the metro- nome while you record Trigger recording PlaybackSending the playback sound to the external effect Applying an effect to the playback soundSelecting the tracks for playback Moving and storing time locations Switching scenes dur- ing playbackProgram playback of songs Moving the current timeFinding a precise time location Locate points LOC1, LOC2, LOC3MarkùM001 Mark pointsStoring a Mark point Moving to a Mark pointPairing on/off Pairing settingsAdjusting the volume of each channel Enabling parameters for pairingAdjusting the Effect Send, AUX Send and Track Status Adjusting the stereo locationUsing the EQ to adjust the tone Adjusting the High EQStoring a scene Switching scenes during a songScene Recalling a sceneRecording a master tape Mixdown Applying an effect dur- ing mixdownEditTrackú Storing IN, OUT and to timesCopying track data Track Copy CpyTr 1 ¿¿Tr 1x 1Ï ¿TrCLP ÏCpyTrCLPÏ¿ Inserting a blank space into the IN-OUT area of a track Inserting a blank space into the track data Insert TrackErasing data from a track Erase Track Ins¿Tr 1?Del¿Tr 1? Deleting data from a track Delete TrackDeleting data from the IN-OUT area of a track Swapping the IN-OUT areas of two tracksMoving a song Song RecoverCopying a song Deleting a songCreating a tempo map Tempo map settingsRecording Midi Clock data from a sequencer Deleting a tempo mapRecording tap tempo Selecting the tempo sourceTo the D8 Using MTC to synchroUsing Midi Clock to synchronize a Midi sequencer to the D8 Nize a Midi sequencerRcvMMCo Ï Using MMC to control the D8 from a Midi sequencerConnecting an external drive DevID 01ÏInitializing and format- ting a drive Exchanging disks on a removable disk driveSaving a song on a removable disk drive Backup ARM 100 ¿ Restore ÏInsNextDsk A01SngNa¿¿HDAT100Ï Saving a song to a DAT recorder BackupBackup Ï ¿DATokÏHDAT100 ¿ Loading a backed-up song from a DAT recorder RestoreLoading a backed-up song from a DAT recorder Restore PlayDAT ÏReference P1 Song number/name display SONG/TRACKEdit SONG/TRACK Drive/song selectMovøI01okœ RenamA01œ SngName œDelI01okœ CpyI1-35ø øB06-40okœP3 Edit Track CpyTr ØTr 1x99œSystem Deleting a mark P2 MIDI/SYNC settingsEdit System Input 1/2 assignARM 100 œ Song backupDiskUtil œ Drive informationØBHD1300œ Song restoreRestore œ ARM 100 ø A01SngN ø ØB02NoDA Initialize/formatPlay Mode Display ModeREC Mode P1 Counter display selectionP2 Post roll time setting Edit Play ModeP1 Pre roll time setting TriggerP1 Tempo map settings P1 Threshold level adjustmentP2 Pre trigger time setting Edit TriggerEdit Tempo P2 Metronome volume settingP1 Tempo source setting MetronomeEdit Metronome P1 Metronome volume settingP2 Metronome mode setting 15. IN/LOC1, OUT/LOC2, TO/LOC3P1 Scene parameter list SceneEdit Scene P2 Deleting a sceneUndo StoreScrub P1 Storing IN/LOC 1, OUT/LOC 2, TO/LOC 3 or a SceneEffect Send Track Status22. EQ Fader P2 External output Aux level settingPAN/BALANCE OffREC Select P1-1 Pairing on/offPair On/Off Snd1-2000P1 Effect select RD1...SE9 Factory Preset, U01...U65 User AreaEffect P1-1Effect program category number selectP2-1 Monitor delay on/off P2 Monitor delay settingsP2-3Monitor delay parameter settings 200msœLoG-15dBœ Edit EffectP1 Editing and saving an effect All Effo RenøRoomEffect Assign Edit Effect AssignTroubleshooting AppendicesMidi sequencer does not synchronize to the D8 Various messages Midi Implementation Chart Block Diagram Effect Assign = Input 1/2 Effect Program List Type EFFECT1 EFFECT2 EFFECT3 EFFECT4Effect Parameter List 4BEQ 4 Band EqualizerNR Noise Reduction Phono Turntable SIM Scukyll Express Metronome Type ListDemo Song List Moonlit sea written by Yuko AsaiD8 Specifications Functions added to the D8 Bouncing tracks
Top Page Image Contents