GE IC3645SR4U404N2 Start switch closed on power up after, Initial key switch closure

DIAGNOSTIC STATUS CODES

SX TRANSISTOR CONTROL Page 25

TRACTION	DESCRIPTION OF STATUS
STATUS CODE
-11	Start switch closed on power up after
	initial key switch closure.
MEMORY RECALL	CORRECTIVE ACTIONS
NO
	SYMPTOM
Circuits valid	Control will not operate.
for	POSSIBLE CAUSE
Traction	Start switch input mis-adjusted or defective.
	• Input voltage at P3 should be less than 60% of
Controller	battery volts at key switch closing. Adjust or
	replace accelerator unit to insure that the
	voltage at P3 is less than 60% of battery volts
	before closing the start switch.
	Short circuit between battery positive and P3 in
	start switch input circuit.
	• Disconnect wire from P3. Check for short
	circuit from this wire to battery positive.

Defective control.

•Disconnect wire from P3. Measure voltage from P3 to negative. Voltage should be zero, if not, replace control.

CAUSE OF STATUS INDICATION

This status code will be displayed when P3 is greater than 60% of battery voltage when the key switch is closed.

TROUBLE-SHOOTING DIAGRAM

KEY

SWITCH

		L	SWITCHSEAT	STARTSW.	FORWARDSW.	REVERSESW.
P1	P17	P2	P6	P3	P4	P5

TRACTION	DESCRIPTION OF STATUS	CAUSE OF STATUS INDICATION
STATUS CODE
-12	Steer angle potentiometer voltage is	This status code will be displayed when P12 is less
	too low.	than 0.39 volts.
MEMORY RECALL	CORRECTIVE ACTIONS	TROUBLE-SHOOTING DIAGRAM
NO
	SYMPTOM
Circuits valid	Control will not operate.
for	POSSIBLE CAUSE
Traction	Steer angle potentiometer input mis-adjusted or
	defective. Loose or missing connections at P9,
Controller	P12 or P8.	P9 P12 P8
	• Input voltage at P12 should be greater than

0.39volts at all times. Insure that the adjustment of the steer potentiometer is in

accordance with Section 9 of this instruction.

Defective control.

• Replace control unit.

STEER ANGLE

POT

January 2000