WARNING
r This product is fueled by propane gas. Propane gas is invisible, odorless, and flammable. An odorant is normally added to help detect leaks and can be described as a “rotten egg” smell. The odorant can fade over time so leaking gas is not always detectable by smell alone.
r Only cylinders marked “propane” must be used.
r Use only propane gas set up for vapor withdrawal.
r Propane gas should be stored or used in compliance with local ordinances and codes or with ANSI/ NFPA 58. Turn off propane and disconnect cylinder when not in use.
r Cylinders must be stored out of reach of children.
CALIFORNIA PROPOSITION 65: WARNING: This fuel, and by products of combustion of this fuel, contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm.
WARNING
BURN HAZARD
r Never leave grill unattended when hot or in use.
r Keep out of reach of children.
CAUTION
SERVICE SAFETY
r Keep all connections and fittings clean. Inspect propane cylinder and grill propane connections for damage before attaching.
r During set up, check all connections and fittings for leaks using soapy water. Never use a flame. Bubbles indicate a leak. Check that the connection is not
r Use as a cooking appliance only. Never alter in any way or use with any device or part not expressly approved by Coleman.
r Clean grill frequently to avoid grease accumulation and possible grease fires.
Technical
Characteristics
Input: 10,000 BTU/h
Category: Pressure regulated propane
Fuel: 16.4 oz. disposable propane cylinders
Regulator: 9930
To Set Up
CONSUMER NOTICE: These assembly instructions are designed for more than one grill model. Some features and components shown may not be included with your grill.
■Remove components from carton. (Fig. 1)
r Table Top Grill r Grill Grate
r Regulator Assembly r Drip Tray
r Lid Handle Assembly r Igniter Assembly
Fig. 1 |
■Assemble handle to lid. Place the handle in proper location. Install the screw and a washer through the inside of the lid and the handle insulator. Tighten the screws with a phillips screwdriver. (Fig. 2)
NOTE: Take care to not
Fig. 2 |