Install the Drip Tray
■Install drip tray below rear of grill. (Fig. 15)
Fig. 15
Install the Electrode and Ground Wires
■Plug the round electrical connector to the round jack at the end of the electrical igniter, and insert the flat one through the burner tube hole, then screwed with screw. (Fig. 16 and Fig. 17)
Burner Tube
Hole
Round
Flat |
Fig. 16 |
| Fig. 17 |
|
|
|
Installing 1 lb. Propane Cylinder
NOTE: Your 9955 Series grill is set up from the factory to use a 1 lb. disposable propane cylinder.
WARNING
Only cylinders marked “Propane” must be used.
WARNING
This procedure MUST be performed OUTDOORS only! Read and follow the directions on the cylinder.
DANGER
r NEVER store a spare L.P. gas supply cylinder under the grill body or inside the grill enclosure or in the vicinity of any heat producing appliance.
Failure to follow this information exactly could result in an explosion and/or fire causing death or serious injury.
CAUTION
Tighten by hand only. DO NOT use tools.
■Before attaching propane cylinder make sure burner knob is in the OFF
position. (Fig. 18)
Fig. 18
■Remove plastic cap from top of propane cylinder and screw cylinder into regulator hand tight.
(Fig. 19)
Fig. 19
■To open lid, unlatch
handle cover and lift up. (Fig. 20)
Fig. 20
■Place grill grate over the burner. (Fig. 21)
Fig. 21
Burner and Orifice
■Proper location of the burner with respect to the orifice is important. To verify the proper installation of the burner tube, view under the regulator assembly cover. The burner tube must be located over the orifice fitting. See Fig. 22 (grill top not shown).
Burner | Burner Tube |
Orifice Fitting
Fig. 22
English - 5