dRelease buttons
eTrim/shave selector
fCutter block
gShaver head base
Shaving
•Put on the shaver head attachment (7) by clicking it in.
•Pressing one of the lock keys, turn the switch clockwise to setting 2.
•Make sure the trim/shave selector is in the «shave» position.
•For best results, always make sure that both, the shaver foil (b) and the trimmer (c) are in contact with the skin (A). Keeping your skin stretched (B), slowly move the appliance against the direction of hair growth. The trimmer first raises all long hairs and cuts them off. Then the flexible foil follows to smooth away any stubble.
•When shaving or trimming in sensitive areas, make sure that you always keep your skin stretched to avoid injuries.
Contour trimming
For trimming precise line and contours, lock the long hair trimmer by sliding the trim/ shave selector (e) to the position «trim» (C1).
Pre-cutting hair for epilation
If you choose to
(a)onto the shaver head. Slide the trim/shave selector to the «trim» position.
Hold the appliance with the OptiTrim comb lying flat on the skin. Guide it with the comb tips against the hair growth as shown in illustration C2.
N.B. As hair does not always grow in the same direction, also guide the appliance slightly diagonally or in different directions in order to achieve best results.
Cleaning the shaver head
After each use, unplug the appliance.
Brush cleaning
•Press the release buttons (d) to remove the shaver head (D1). Tap the bottom of the shaver head gently on a flat surface (not on the foil).
•Brush out the cutter block and the inside of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil.
Cleaning with water
Press the release buttons (d) to remove the shaver head. Rinse the shaver head and the cutter block separately under running water (D2). Leave the cutter block and the foil frame to dry separately before reattaching them.
Keeping your shaver head attachment in top shape
•The shaving parts need to be lubricated regularly every 3 months (E). If you clean the shaver head under running water, please lubricate it after every cleaning.
•Apply some light machine oil or vaseline to the shaver foil and the metal parts of the long hair trimmer. Then remove the shaver head and also apply a tiny amount of vaseline as shown in picture section (E).
•The shaver foil and the cutter block are precision parts that wear out with time. To maintain optimum shaving performance, replace your foil and cutter block when you notice a reduced shaving performance.
•Do not shave with a damaged foil or cord.
How to replace the shaving parts Shaver foil: Press the release buttons to remove the shaver head. To remove the shaver foil, press the foil frame (F). To
15