English
Your new Philips Salon Multi Styler has been specially designed to give beautiful styling results. It is quick and easy to use. We hope you will enjoy using your Salon Multi Styler - the hairstyler with which you can create any desired hairdo.
In order to get the best results, please read the instructions carefully before use. Also refer to the illustrations on
Important
•Before connecting the appliance, check that the voltage indicated on the type plate corresponds to the local mains voltage.
•Do not use this product near water in e.g. baths, washbasins, sinks.
If the product falls into water, unplug it immediately and dispose of it. It must not be used again.
•Always ensure that the attachments are completely dry (on the inside as well as the outside!) before affixing them to the styler.
•Always switch the appliance off before putting it down, even if it is only for a moment.
•For additional protection, the installation of a residual current device (RCD) with a rated residual operating current not exceeding 30 mA is advisable in the electric circuit supplying the bathroom. Ask your electrician for advice.
•Even when the appliance is switched off, the electricity has not been cut off. Always pull out the mains plug when the appliance is not being used.
•Never obstruct the air inlet grille.
•This product is equipped with an automatic overheating protection device. If the appliance overheats, it will switch off. Unplug the appliance. After cooling down for a few minutes, the appliance can be used again. Before reusing, check the air inlet grille for possible blockage by fluff, hair, etc. If in doubt, consult your dealer or an Authorised Philips Service Centre.
4