SECTION
SECTION 2—ASSEMBLY
Assembling the Patient Lift
Assembling the Mast Assembly to the Base
NOTE: The mast assembly may be removed from the base for storage or transporting. The mast assembly MUST be properly secured to the base assembly before use.
NOTE: For this procedure, refer to FIGURE 2.1.
1.Put the base on a level surface so all casters make contact with the floor.
2.Lock the rear casters. Refer to Detail “A”.
3.Unscrew the top knob and remove it from the base.
4.Loosen the bottom knob, but leave it screwed into the base.
5.Put the tube of the mast assembly into the hole in the base.
6.While supporting the mast assembly, tighten the bottom plastic knob.
7.Screw the top plastic knob into the hole in the base.
Push tab down to lock
Push tab up to unlock
Mast
Assembly
Base
Caster | Top Plastic Knob |
Bottom Plastic Knob
FIGURE 2.1 Assembling the Mast Assembly to the Base
Jasmine™ Patient Lift | 10 | Part No 1150704 |