AT&T 7630 user manual Hold, Temporary Tone, Voice Security, Page/Intercom

Page 10

TELEPHONE OPERATION

At the Handset

Hold

Press Hto put a call on hold. The PHONE light on the handset flashes.

To return to the call, press Hagain

— OR —

Press Pon the handset

— OR —

Press K on the base

— OR —

Lift the handset of an extension phone on the same line.

Temporary Tone

NOTE: If you have touch tone service, you do not need to use the Temporary Tone feature.

If you have dial pulse (rotary) service, this feature allows you to enter codes or tones needed to operate certain answering machines or to use electronic banking services, calling cards, and other special services. This feature will operate most special services; however, some services may actually require a touch tone line. To be sure, ask the company that provides the special service.

1Dial the call, then press *. Any dial buttons pressed after this send touch tone signals.

2After you hang up, the phone automatically returns to dial pulse (rotary) dialing.

Voice Security

Activating Voice Security reduces the chance of your conversation being inadvert- ently overheard by a neighbor’s cordless phone or other radio receiving equipment within range of your phone.

To activate Voice Security, press s. The SECURE light goes on. To deactivate Voice Security, press sagain.

NOTE: Activating this feature may reduce the sound quality of your calls.

Page/Intercom

1Press Ion the handset. When the INTERCOM/LOW BATT light on the handset goes on, you can speak to the base, and the base can respond.

2Press Ion the handset to close the intercom connection.

9

7630_book.1AT&T

9

8/12/98, 6:28 PM

Image 10

Contents Part Please read Part 1 Important Product Information Contents Installation Turn answering Telephone line cord Table/Desk Installation Set the dial mode For Wall InstallationCheck for dial tone Installation Telephone Operation Voice Security HoldTemporary Tone Page/IntercomHandset Locator Power Reserve FeatureRecording a Phone Conversation Storing a Pause in a Memory Number Telephone MemoryStoring Memory Numbers OR- Press MReplacing a Stored Number Dialing Memory NumbersDialing Number Stored in M1 Memory GuardConecting to a Call With the Speakerphone Speakerphone Volume ControlMute Operating Range Changing ChannelsAnswering System SET-UP Speaker Volume ControlSetting the Clock Turning the System On/OffSelecting Your Announcement Announcement OptionsRecording Your Announcement Ring Select and Toll Saver Feature Set-UpAnnouncement Play/Silent Deleting an AnnouncementPriority Call Signal Remote Access CodeAudible Message Alert Reviewing Feature Settings Base Ringer SettingChanging the Priority Calling Code Call Screening/Intercept Answering System OperationAnswering Calls Announcement BypassListening to Your Messages Saving MessagesDeleting Messages Message Guard Power Fail Protection SystemRecording a Memo From a Touch Tone Phone Connecting with the Answering SystemFrom the Cordless Handset Voice Help MenuPlaying Messages Remote Access CommandsConnect with the answering system Reviewing your announcement Call ScreeningRecording Outgoing Announcement To monitor a callChanging Settings Recording a Message When System is OffRemote ON/OFF Exit Remote Access Reviewing SettingsAudible Signals Handset Batteries Replacing the Handset Battery Pack If the phone does not work at all If you hear two-beep signal when you try to use the handsetCase of Difficulty If you have no dial toneIf you hear other calls while using the phone If you hear noise or interference when using the phoneIf the phone does not ring when you receive a call If you hear noise in the handset and the buttons don’t workIf CL appears in the Message Counter If messages are incompleteIf you have difficulty hearing messages If your outgoing announcement isnt clearAnswering System Operation 7630WC.1AT&T 12/98, 626 PM