AT&T 7630 user manual Installation

Page 8

INSTALLATION

5Feed the free end of the line cord through the rectangular opening in the center of the bracket.

6Replace the bracket.

Place the bracket back on the base so that the thicker end will be at the bottom of the base when wall-mounted.

7Connect the line cord to the wall jack. Make sure it snaps firmly into place.

8Mount the base on the wall.

Hold the base so the mounting knobs on the wall plate fit the keyhole slots on the base. Slide the base down onto the knobs until it locks into place.

9Plug the AC adapter on the power cord into an electrical outlet not controlled by a wall switch.

CAUTION: Use only the AC power adapter supplied with this tele- phone. Power Supply HADW-1; Input:120V AC, 60 Hz, 16 W; Output 12V DC, 900mA.

Note: When the system is first connected to AC power, it begins an automatic initialization routine. After this routine is complete, the Message Counter flashes CL, indicating the clock needs to be set. See "Setting the Clock" in the Answering System Set-up section of this manual.

10 Follow Steps 7 to 10 in Table/Desk Installation.

7

7630_book.1AT&T

7

8/12/98, 6:28 PM

Image 8
Contents Part Please read Part 1 Important Product Information Contents Installation Turn answering Telephone line cord Table/Desk Installation Check for dial tone For Wall InstallationSet the dial mode Installation Telephone Operation Hold Temporary ToneVoice Security Page/IntercomRecording a Phone Conversation Power Reserve FeatureHandset Locator Telephone Memory Storing Memory NumbersStoring a Pause in a Memory Number OR- Press MDialing Memory Numbers Dialing Number Stored in M1Replacing a Stored Number Memory GuardMute Speakerphone Volume ControlConecting to a Call With the Speakerphone Operating Range Changing ChannelsSpeaker Volume Control Setting the ClockAnswering System SET-UP Turning the System On/OffRecording Your Announcement Announcement OptionsSelecting Your Announcement Feature Set-Up Announcement Play/SilentRing Select and Toll Saver Deleting an AnnouncementAudible Message Alert Remote Access CodePriority Call Signal Changing the Priority Calling Code Base Ringer SettingReviewing Feature Settings Answering System Operation Answering CallsCall Screening/Intercept Announcement BypassListening to Your Messages Saving MessagesRecording a Memo Message Guard Power Fail Protection SystemDeleting Messages Connecting with the Answering System From the Cordless HandsetFrom a Touch Tone Phone Voice Help MenuConnect with the answering system Remote Access CommandsPlaying Messages Call Screening Recording Outgoing AnnouncementReviewing your announcement To monitor a callRemote ON/OFF Recording a Message When System is OffChanging Settings Audible Signals Reviewing SettingsExit Remote Access Handset Batteries Replacing the Handset Battery Pack If you hear two-beep signal when you try to use the handset Case of DifficultyIf the phone does not work at all If you have no dial toneIf you hear noise or interference when using the phone If the phone does not ring when you receive a callIf you hear other calls while using the phone If you hear noise in the handset and the buttons don’t workIf messages are incomplete If you have difficulty hearing messagesIf CL appears in the Message Counter If your outgoing announcement isnt clearAnswering System Operation 7630WC.1AT&T 12/98, 626 PM