AT&T 7630 Dialing Memory Numbers, Dialing Number Stored in M1, Replacing a Stored Number

Page 13

TELEPHONE MEMORY

At the Handset

Storing a Number Just Dialed

Whenever you make a telephone call, you can store the number you dialed in memory. Press Rinstead of entering the telephone number when storing memory numbers.

Dialing Memory Numbers

1Press P.

2Press p.

3Press the number buttons (01 to 20) you assigned to the number you’re calling.

For example, to dial the number you assigned to location 6, press P, p, 0, 6.

Dialing Number Stored in M1

1Press P.

2Press M.

Replacing a Stored Number

You can replace a stored number by storing a new number in its place.

Memory Guard

The phone numbers you store in memory are protected from loss when you change the handset battery, or in the event of a power failure.

1 2

7630_book.1AT&T

12

8/12/98, 6:28 PM

Image 13
Contents Part Please read Part 1 Important Product Information Contents Installation Turn answering Telephone line cord Table/Desk Installation Set the dial mode For Wall InstallationCheck for dial tone Installation Telephone Operation Temporary Tone HoldVoice Security Page/IntercomHandset Locator Power Reserve FeatureRecording a Phone Conversation Storing Memory Numbers Telephone MemoryStoring a Pause in a Memory Number OR- Press MDialing Number Stored in M1 Dialing Memory NumbersReplacing a Stored Number Memory GuardConecting to a Call With the Speakerphone Speakerphone Volume ControlMute Changing Channels Operating RangeSetting the Clock Speaker Volume ControlAnswering System SET-UP Turning the System On/OffSelecting Your Announcement Announcement OptionsRecording Your Announcement Announcement Play/Silent Feature Set-UpRing Select and Toll Saver Deleting an AnnouncementPriority Call Signal Remote Access CodeAudible Message Alert Reviewing Feature Settings Base Ringer SettingChanging the Priority Calling Code Answering Calls Answering System OperationCall Screening/Intercept Announcement BypassSaving Messages Listening to Your MessagesDeleting Messages Message Guard Power Fail Protection SystemRecording a Memo From the Cordless Handset Connecting with the Answering SystemFrom a Touch Tone Phone Voice Help MenuPlaying Messages Remote Access CommandsConnect with the answering system Recording Outgoing Announcement Call ScreeningReviewing your announcement To monitor a callChanging Settings Recording a Message When System is OffRemote ON/OFF Exit Remote Access Reviewing SettingsAudible Signals Handset Batteries Replacing the Handset Battery Pack Case of Difficulty If you hear two-beep signal when you try to use the handsetIf the phone does not work at all If you have no dial toneIf the phone does not ring when you receive a call If you hear noise or interference when using the phoneIf you hear other calls while using the phone If you hear noise in the handset and the buttons don’t workIf you have difficulty hearing messages If messages are incompleteIf CL appears in the Message Counter If your outgoing announcement isnt clearAnswering System Operation 7630WC.1AT&T 12/98, 626 PM