AT&T 7630 user manual Handset Batteries

Page 29

HANDSET BATTERIES

The handset batteries need charging when:

The phone beeps four times when you press P.

The INTERCOM/LOW BATT light on the handset is on when the phone is off.

The INTERCOM/LOW BATT light on the handset flashes when the phone is on.

The phone does not respond when you press P, and no lights go on.

Place the handset in the base so the CHARGING light goes on. The batteries will be fully charged in 4 hours. Once the batteries are fully charged, you need only put the handset in the base when the LOW BATT light flashes.

If it is more convenient for you, you can leave the handset in the base all the time. It is impossible to overcharge the batteries. If you get a low battery signal even after 4 hours of charging, the battery should be replaced.

CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and follow these instructions carefully.

Use only replacement battery 4051.

Do not dispose of the battery in a fire. The cell might explode. Check with local codes for special disposal instructions.

Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

Charge the battery provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual.

Observe proper polarity orientation between the battery and battery charger.

2 8

7630_book.1AT&T

28

8/12/98, 6:29 PM

Image 29
Contents Part Please read Part 1 Important Product Information Contents Installation Turn answering Telephone line cord Table/Desk Installation Check for dial tone For Wall InstallationSet the dial mode Installation Telephone Operation Temporary Tone HoldVoice Security Page/IntercomRecording a Phone Conversation Power Reserve FeatureHandset Locator Storing Memory Numbers Telephone MemoryStoring a Pause in a Memory Number OR- Press MDialing Number Stored in M1 Dialing Memory NumbersReplacing a Stored Number Memory GuardMute Speakerphone Volume ControlConecting to a Call With the Speakerphone Changing Channels Operating RangeSetting the Clock Speaker Volume ControlAnswering System SET-UP Turning the System On/OffRecording Your Announcement Announcement OptionsSelecting Your Announcement Announcement Play/Silent Feature Set-UpRing Select and Toll Saver Deleting an AnnouncementAudible Message Alert Remote Access CodePriority Call Signal Changing the Priority Calling Code Base Ringer SettingReviewing Feature Settings Answering Calls Answering System OperationCall Screening/Intercept Announcement BypassSaving Messages Listening to Your MessagesRecording a Memo Message Guard Power Fail Protection SystemDeleting Messages From the Cordless Handset Connecting with the Answering SystemFrom a Touch Tone Phone Voice Help MenuConnect with the answering system Remote Access CommandsPlaying Messages Recording Outgoing Announcement Call ScreeningReviewing your announcement To monitor a callRemote ON/OFF Recording a Message When System is OffChanging Settings Audible Signals Reviewing SettingsExit Remote Access Handset Batteries Replacing the Handset Battery Pack Case of Difficulty If you hear two-beep signal when you try to use the handsetIf the phone does not work at all If you have no dial toneIf the phone does not ring when you receive a call If you hear noise or interference when using the phoneIf you hear other calls while using the phone If you hear noise in the handset and the buttons don’t workIf you have difficulty hearing messages If messages are incompleteIf CL appears in the Message Counter If your outgoing announcement isnt clearAnswering System Operation 7630WC.1AT&T 12/98, 626 PM