AT&T 7630 Base Ringer Setting, Reviewing Feature Settings, Changing the Priority Calling Code

Page 20

ANSWERING SYSTEM SET-UP

Changing the Priority Calling Code

The priority calling code comes set to 999, but you can change it to any three-digit number from 500 to 999 following the directions below.

NOTE: Do not use the same code as the Remote Access Code. If you set the Remote Access Code and the Priority Calling Code to the same number, the phone will always interpret that number as the Remote Access Code.

1Press C.

2Press and release uuntil you hear "Priority Call Code is...". The system announces the current Priority Calling Code.

3Press nor Nto change the first digit. Press uto move to the second digit.

4Press nor Nto change the second digit. Press uto move to the third digit.

5Press nor Nto change the third digit. Press uto save. The system announces the new Priority Calling Code.

Base Ringer Setting

1Press C.

2Press and release uuntil you hear "Base ringer is...". The Message Counter displays + if the ringer is on; if the ringer is off.

3Press nto change the setting. When you set the ringer to off, the BASE RINGER OFF light on the base goes on.

Reviewing Feature Settings

You can check the status of the feature settings by pressing u.

1 9

7630_book.1AT&T

19

8/12/98, 6:29 PM

Image 20
Contents Part Please read Part 1 Important Product Information Contents Installation Turn answering Telephone line cord Table/Desk Installation Check for dial tone For Wall InstallationSet the dial mode Installation Telephone Operation Hold Temporary ToneVoice Security Page/IntercomRecording a Phone Conversation Power Reserve FeatureHandset Locator Telephone Memory Storing Memory NumbersStoring a Pause in a Memory Number OR- Press MDialing Memory Numbers Dialing Number Stored in M1Replacing a Stored Number Memory GuardMute Speakerphone Volume ControlConecting to a Call With the Speakerphone Operating Range Changing ChannelsSpeaker Volume Control Setting the ClockAnswering System SET-UP Turning the System On/OffRecording Your Announcement Announcement OptionsSelecting Your Announcement Feature Set-Up Announcement Play/SilentRing Select and Toll Saver Deleting an AnnouncementAudible Message Alert Remote Access CodePriority Call Signal Changing the Priority Calling Code Base Ringer SettingReviewing Feature Settings Answering System Operation Answering CallsCall Screening/Intercept Announcement BypassListening to Your Messages Saving MessagesRecording a Memo Message Guard Power Fail Protection SystemDeleting Messages Connecting with the Answering System From the Cordless HandsetFrom a Touch Tone Phone Voice Help MenuConnect with the answering system Remote Access CommandsPlaying Messages Call Screening Recording Outgoing AnnouncementReviewing your announcement To monitor a callRemote ON/OFF Recording a Message When System is OffChanging Settings Audible Signals Reviewing SettingsExit Remote Access Handset Batteries Replacing the Handset Battery Pack If you hear two-beep signal when you try to use the handset Case of DifficultyIf the phone does not work at all If you have no dial toneIf you hear noise or interference when using the phone If the phone does not ring when you receive a callIf you hear other calls while using the phone If you hear noise in the handset and the buttons don’t workIf messages are incomplete If you have difficulty hearing messagesIf CL appears in the Message Counter If your outgoing announcement isnt clearAnswering System Operation 7630WC.1AT&T 12/98, 626 PM