AT&T 944 user manual Install one 9V battery

Page 10

INSTALLATION

2Install one 9V battery.

•Press in on the tabs and remove the telephone base.

•Use a small Phillips head screwdriver to remove the screw and open the battery door.

•Insert the 9V battery (included), and replace the screw to close the battery door.

•Replace the telephone base.

NOTE: The battery retains telephone memory in the event of a power failure. If power fails and a working battery is installed, all four lines of this phone will work only to answer calls with the handset or headset, and dial calls using the keypad and the Speed Dial or Redial features. No other features will work until power is restored.

3Connect the telephone line cords to the telephone. Please refer to line cord connection instructions in Step 2 of “Table/Desk Installation’ on page 7.

4Turn the base, as shown, and attach it to the bottom of the phone.

9

Image 10

Contents Four-Line Intercom Speakerphone Part 1 Important Product InformationContents Before YOU Begin Glossary Features List Feature Function Setting OptionsAudible Signals When you hear It meansTable/Desk Installation InstallationInstall one 9V battery Connect the telephone line cords to the telephone Two Two-Line JacksWall Installation Install one 9V battery Connect the power adapter to the telephone Mount the phone on the wallTwo Two-Line Jacks Convenience Ports Feature SET UP Feature OptionsAssign an Extension Number to Your Phone Set the Time/DateTurn the Ringer On or Off for Each Line Select the Ringer Type Set Delay RingTurn Line Usage On or Off for Each Line Assign the Line Group for this Phone Assign the Prime Line Line PreferenceTurn Auto-Mute On or Off Set the Flash Time Set Audio ModeSet the Dial Mode Turn Hold Reminder On or OffErase All Settings and Return the Phone to Default Settings Program the Centrex Console Delayed Ring TimeSet Your Phone to be the Centrex Console Phone Telephone Operation Handset Telephone OperationMaking or Answering a Call SpeakerphoneSwitching Modes TimerPause Do Not Disturb Canceling Call PrivacyCall Privacy Restoring Call PrivacyLine-in-Use Lights VolumeRedial Hold Switch Between LinesAuto Redial Speakerphone or HeadsetTemporary Tone Dialing MuteFlash Conference CallsTo talk privately with one party Low Battery IndicatorTransfer a Call To drop one lineSpeed Dial Operation Reviewing a Speed Dial Entry Storing a Number in a Speed Dial LocationMaking a Speed Dial Call Intercom Operation Basic Intercom Operations Making an Intercom Call with the HandsetAnswering an Intercom Call Switching Between an Intercom Call and a Single-phoneMaking an Intercom Call with the Speakerphone or Headset Making a Single-phoneMaking an Intercom Conference Call Paging All PhonesAnswering a System-wide Room MonitorUsing a Fax Switch Adding a FAX MachineCase of Difficulty Intercom Paging Signal Not ReceivedLine Lights Remain On When No Line is Connected Telephone Does Not RingOperation During a Power Failure Tone Signals Do Not Activate a Remote DeviceDisplay Screen is Blank Expanding the Phone System Line GroupsPrivate Lines Enabling the Console Phone Setup ChecklistCentrex Operation Console OperationAnswering a Delayed Ring Setting Ring Delay DurationPicking Up Another Station’s Line Audio Mode 4 IndexReset ALL Advanced American Telephones. All rights reserved