AT&T 1070 manual Appears to be dead on, Or Speaker, Is no dial tone on this

Troubleshooting

• If Line 1 is a DSL line, have a professional install a splitter on the telephone line. See the installation guide and contact your DSL service provider for more information.

• If the wiring for your system is greater than 600 feet, some of the advanced features may not work properly. You may have to remove some of the phones from remote areas.

	• Check to make sure that each telephone set
	has a unique extension number. If the sets
	receive AC power at the same time, either at
	initial installation or after a power failure, the
	extension numbers may be the same. Refer to
	the EXTENSION NUMBER section on page 32.
There is no dial tone.	• First, try all the suggestions of My telephone
	appears to be dead on page 86.
	• The telephone line cord might be malfunctioning.
	Try installing a new telephone line cord.
	• Disconnect the telephone base from the telephone
	jack and connect a different telephone. If there
	is no dial tone on the telephone either, the
	problem is in your wiring or local service. Contact
	your local telephone company.
	• Make sure a line is selected. Press a line button
	or [ SPEAKER].
	• Make sure the [HOLD] key is not pressed.
	• If there is no dial tone when the [HEADSET] key
	is pressed, make sure the headset is firmly con-
	nected in the HEADSET jack.
I cannot dial out.	• First, try all the above suggestions in There
	is no dial tone on this page.
	• Make sure there is a dial tone before dialing. It is
	normal if the telephone takes a second or two to
	synchronize before producing a dial tone. Wait an
	extra second before dialing.
	• Check that all the telephones connected to the
	same telephone line are hung up.
	• Make sure the telephone is set to the correct
	dial mode (pulse dial or tone dial) for the service
	in your area. Refer to the TONE/PULSE section
	of the user’s manual to set the dial mode.

87