IP 300 User Manual
What if your network is using Static IP Addressing ?
When your LAN settings are using static IP addressing, you should
1.Changing DHCP to static in the IP Phone
Before you assign a static IP address, the IP Phone’s DHCP mode must be
changed.
1. In the setting mode
, press the SPK button to access the IPtype
screen.
2. Press Local IP button, followed by “0” to change the DHCP setting to static
and then press “SPK” to confirm. You will see:
3.Press SPK button again to enter the LAN parameters. You must now enter your LAN parameters individually as follows:
2.Entering Your LAN Parameters
If you have changed the IP type in your IP Phone and you know your LAN parameters, you are ready to begin entering the information.
The parameters you will enter are: An IP address
A subnet mask
A gateway address
A primary DNS address
A secondary DNS address
a. Enter the Local IP address
1. When
appears, press SPK followed by Local IP button to
input the IP address.
2. Use the dialpad to enter the IP address. For example: 192.168.1.113
(Please press “*” button to input “.” separating the 4 groups of numbers.
In this case, press: 192*168*1*113 on the dialpad)
3. Press SPK to confirm and input the next parameter