Perfectone Net Ware IP 300 manual Relevant usage ftp

Page 50

IP 300 User Manual

Usage: the system connects to the FTP server auto to get the corresponding file and deal with it.

Relevant usage: ftp X

X ranged from 0 through 2:

X-0: Connect to FTP Server to get the file of updating program and save it to the SDRAM of the phone. Then the file can be read by PalmTool. This operation aims at testing.

X-1: Connect to FTP Server to get the file of updating program and update program Flash. This operation aims at updating program.

X-2: Connect to FTP Server to get the file of updating dial rules and update program Flash. This operation aims at updating dial rule.

Note When you use ftp 0 and ftp 1 commands, if the file get from FTP server is too large or the net speed is too slow, then the process will not be seen in telnet window. Please be patient. Using ftp command in telnet to get file spends almost same minutes as getting file using phone. So if nothing is displayed after too long time, it means that ftp is fail.

Note All the Telnet commands of IP-300 IP phone should be written in low case and the password is case sensitive.

50

Image 50

Contents Page Page Before Getting Started Product DescriptionHardware FeaturesFunction Keys of IP 300 IP Phone Introduction Normal State SoftwareElectric requirements Standard and ProtocolOperating requirements IP 300 IP Phone supports following standard and protocolPower 5 W max SizeWhat is the IP Addressing of your network? Connecting the Handset and CablesPage What if your network is using Dhcp Addressing? Using the Keypad to Configure the IP phoneEnter setting mode Page What if your network is using Static IP Addressing ? Enter the Local IP addressEnter the subnetmask address 202.67.240.221Menu Structure Page Page Using the Web Browser to configure the IP phone Network Setting Page Protocol settings Page Page Page Service id Voiptest.com Page Phone settings Page Page Audio settings Other settings Setting Page using ordinary pin with Debug set as 0 disable Phone Book Illustration Telnet Configuration Exit with saving all configurations and restart IP Save current settings to designated positionLoad designated settings to current position Detail description of IP 300 Telnet commands Command ?Will be displayed Command set Syntax description set keywords value Detailed description Set iptypeSet ip Set pppidSet ppppin Set subnetmaskSet service type Set nataddr Set nattraversalSet serviceid Set nattraversalSet account Set nat ttlSet phonenumber Set pinSet controlport Set signalportSet registerport Register ttlSet localtype Set rtpportJitter sizeX Set dtmfSet iddcode Set dialnumberNumber. set dddcode Set iddprefixSet localpreifx Set dddprefixSet innerline Set nonlocalprefixSet fwdalways Set fwdpoweroffSet fwdnumber Set fwdbusySet audioframes Command store Set passwordSet upgradeaddr Relevant Usage store Command loadFtp command Syntax description ftp value Relevant Usage load Command exitRelevant usage None Command write Relevant usage ftp To place a call Call another IP 300 IP phone under the same GatekeeperStoring a Number into Memory Dial Receiving a CallSpeed Dialing Dial a Stored NumberKeys Press Press Twice