Perfectone Net Ware IP 300 manual Set rtpport, Jitter sizeX, Set localtype, Set dtmf, Set dialplan

Page 43

IP 300 User Manual

set rtpport XXXX

RTP port is the port transferring and receiving voice flow using UDP

protocol. XXXX is ranged from 1024 through 65535.

Jitter size:X

Setting RTP date stream anti-buffer size. The specific value ranges 0-32.The unit is Tone Frame number. (The value is bigger, the tone frame number is much more in the buffer area and the time-lapse is longer all ordingly.)

set calltype X

Set call type of the phone. X is ranged from 0 through 2: 0: call out in

normal way; 1: call out in faststart way; 2: call out in faststart and

tunneling way. It is a recommended way with H323 protocol used.

set localtype X

With H323 protocol used, this command used to set how IP phone log in

gatekeeper. X is ranged from 0 through 2: 0: use phone number as

E.164 and H323 ID to login the GK; 1: use phone number as E.164 and

designated H323 ID by set account XXX command; 2: H235 account,

with encryption being supported by GK, set value as 2.

set dtmf X

Set DTMF relay type. X is ranged form 0 through 3: 0:control string

1:inband audio 2: signal keypad		3:rfc 2833.	.
set dialplan X	.	.
set dialplan X

Enable/disable dial plan and dial number. Parameter X ranged from 0

43

Image 43

Contents Page Page Product Description Before Getting StartedSoftware FeaturesFunction Keys of IP 300 IP Phone Introduction Normal State HardwareIP 300 IP Phone supports following standard and protocol Standard and ProtocolOperating requirements Electric requirementsSize Power 5 W maxConnecting the Handset and Cables What is the IP Addressing of your network?Page Enter setting mode Using the Keypad to Configure the IP phoneWhat if your network is using Dhcp Addressing? Page Enter the Local IP address What if your network is using Static IP Addressing ?202.67.240.221 Enter the subnetmask addressMenu Structure Page Page Using the Web Browser to configure the IP phone Network Setting Page Protocol settings Page Page Page Service id Voiptest.com Page Phone settings Page Page Audio settings Other settings Setting Page using ordinary pin with Debug set as 0 disable Phone Book Illustration Telnet Configuration Detail description of IP 300 Telnet commands Command ? Save current settings to designated positionLoad designated settings to current position Exit with saving all configurations and restart IPWill be displayed Detailed description Set iptype Command set Syntax description set keywords valueSet subnetmask Set pppidSet ppppin Set ipSet service type Set nattraversal Set nataddrSet nattraversal Set serviceidSet pin Set nat ttlSet phonenumber Set accountRegister ttl Set signalportSet registerport Set controlportSet dtmf Set rtpportJitter sizeX Set localtypeSet iddprefix Set dialnumberNumber. set dddcode Set iddcodeSet nonlocalprefix Set dddprefixSet innerline Set localpreifxSet fwdbusy Set fwdpoweroffSet fwdnumber Set fwdalwaysSet audioframes Relevant Usage store Command load Set passwordSet upgradeaddr Command storeRelevant usage None Command write Relevant Usage load Command exitFtp command Syntax description ftp value Relevant usage ftp Call another IP 300 IP phone under the same Gatekeeper To place a callDial a Stored Number Receiving a CallSpeed Dialing Storing a Number into Memory DialKeys Press Press Twice