Perfectone Net Ware IP 300 manual Set service type

Page 38

IP 300 User Manual

IP-300 IP phone.

set dns XXX.XXX.XXX.XXX

With iptype set as 0, use this command to set IP address of DNS server.

set dns2 XXX.XXX.XXX.XXX

With iptype set as 0, use this command to set IP of backup DNS server.

set mac XX-XX-XX-XX-XX-XX

Set MAC address of the IP-300 IP phone. Parameter xx-xx-xx-xx-xx-xx must be an HEX number.

set protocol X

Set protocol of the IP-300 IP phone. Parameter X ranged from 0 through

5:0 – H323 protocol; 1 -- Sip protocol; 2 -- Mgcp protocol; 3- Net2phone private service,4-iax 5-wp.

set service X

According to different protocol, set use protocol service or not. X ranged from 0 through 1. 0: do not use service; 1: use service.

set service type X

Enable/disable the repaid and service system .choose the repaid server provider. Parameter x ranged from 0 through 29: 0: disable repaid card;

1:use Mediaring service; 2: use eTalk card; 3: use Auvtech system; 4: use UTstarcom service; 5: use Ringtec service; 6: use Smartcon service;

7:use dda service; 8: use vida service; 9: use citron system; 10: use asiasoft system; 11: use uptech system; 12: use zte system; 13: use

38

Image 38
Contents Page Page Before Getting Started Product DescriptionHardware FeaturesFunction Keys of IP 300 IP Phone Introduction Normal State SoftwareElectric requirements Standard and ProtocolOperating requirements IP 300 IP Phone supports following standard and protocolPower 5 W max SizeWhat is the IP Addressing of your network? Connecting the Handset and CablesPage What if your network is using Dhcp Addressing? Using the Keypad to Configure the IP phoneEnter setting mode Page What if your network is using Static IP Addressing ? Enter the Local IP addressEnter the subnetmask address 202.67.240.221Menu Structure Page Page Using the Web Browser to configure the IP phone Network Setting Page Protocol settings  Page Page Page Service id Voiptest.com Page Phone settings Page Page Audio settings Other settings Setting Page using ordinary pin with Debug set as 0 disable Phone Book Illustration Telnet Configuration Exit with saving all configurations and restart IP Save current settings to designated positionLoad designated settings to current position Detail description of IP 300 Telnet commands Command ? Will be displayed Command set Syntax description set keywords value Detailed description Set iptypeSet ip Set pppidSet ppppin Set subnetmaskSet service type Set nataddr Set nattraversalSet serviceid Set nattraversalSet account Set nat ttlSet phonenumber Set pinSet controlport Set signalportSet registerport Register ttlSet localtype Set rtpportJitter sizeX Set dtmfSet iddcode Set dialnumberNumber. set dddcode Set iddprefixSet localpreifx Set dddprefixSet innerline Set nonlocalprefixSet fwdalways Set fwdpoweroffSet fwdnumber Set fwdbusySet audioframes Command store Set passwordSet upgradeaddr Relevant Usage store Command loadFtp command Syntax description ftp value Relevant Usage load Command exitRelevant usage None Command write Relevant usage ftp To place a call Call another IP 300 IP phone under the same GatekeeperStoring a Number into Memory Dial Receiving a CallSpeed Dialing Dial a Stored NumberKeys Press Press Twice