Perfectone Net Ware IP 300 manual

Page 8

IP 300 User Manual

Jack. Plug the other end of the cable into an appropriate LAN or DSL/Cable router port or a HUB.

3.Power on IP phone: plug the power cord adapter into the Power Jack. Then plug the other end of the power cord adapter into the appropriate wall outlet.

If your LAN or router is using DHCP, after finishing the above 3 steps, the LCD should display

a series of messages ending with: “Ready for Call” within a few seconds.

Note: If you are not sure whether DHCP service should be present, try the following:

Check with your network administrator to find out if the system uses DHCP, or

If your IP Phone is connecting with a router, check to see whether it is

configured to provide DHCP addressing.

If your LAN uses static addressing, “Waiting Logon” will display until you enter the IP Phone’s network settings. Step-by-step instructions for configuring your IP Phone are provided in Section 3: Configuring the IP Phone of this manual.

8

Image 8

Contents Page Page Before Getting Started Product DescriptionFeatures Function Keys of IP 300 IP Phone Introduction Normal StateHardware SoftwareStandard and Protocol Operating requirementsElectric requirements IP 300 IP Phone supports following standard and protocolPower 5 W max SizeWhat is the IP Addressing of your network? Connecting the Handset and CablesPage What if your network is using Dhcp Addressing? Using the Keypad to Configure the IP phoneEnter setting mode Page What if your network is using Static IP Addressing ? Enter the Local IP addressEnter the subnetmask address 202.67.240.221Menu Structure Page Page Using the Web Browser to configure the IP phone Network Setting Page Protocol settings Page Page Page Service id Voiptest.com Page Phone settings Page Page Audio settings Other settings Setting Page using ordinary pin with Debug set as 0 disable Phone Book Illustration Telnet Configuration Save current settings to designated position Load designated settings to current positionExit with saving all configurations and restart IP Detail description of IP 300 Telnet commands Command ?Will be displayed Command set Syntax description set keywords value Detailed description Set iptypeSet pppid Set ppppinSet ip Set subnetmaskSet service type Set nataddr Set nattraversalSet serviceid Set nattraversalSet nat ttl Set phonenumberSet account Set pinSet signalport Set registerportSet controlport Register ttlSet rtpport Jitter sizeXSet localtype Set dtmfSet dialnumber Number. set dddcodeSet iddcode Set iddprefixSet dddprefix Set innerlineSet localpreifx Set nonlocalprefixSet fwdpoweroff Set fwdnumberSet fwdalways Set fwdbusySet audioframes Set password Set upgradeaddrCommand store Relevant Usage store Command loadFtp command Syntax description ftp value Relevant Usage load Command exitRelevant usage None Command write Relevant usage ftp To place a call Call another IP 300 IP phone under the same GatekeeperReceiving a Call Speed DialingStoring a Number into Memory Dial Dial a Stored NumberKeys Press Press Twice