Perfectone Net Ware IP 300 manual Set pppid, Set ppppin, Set ip, Set subnetmask, Set router

Page 37

IP 300 User Manual

router is configured to use DHCP addressing, the IP phone’s LAN parameters will automatically be configured as soon as it is connected to the LAN or router and powered up; 2: use PPPoE mode. Those ADSL and Cable Modem users please select this item for it is a protocol especially designed for them. With this system, ADSL ISP automatically assigns all the required IP parameters to any device connected to it when the device log on; 3: use modem mode. Those who use IP phone with modem, please set the value as 3.

set pppid XXX

With iptype set as 2, use this command to set ADSL ID; with iptype set as 3, use this command to set Modem ID.

set ppppin XXX

With iptype set as 2, use this command to set ADSL pin; with iptype set as 3, use this command to set Modem pin.

set ip XXX.XXX.XXX.XXX

With iptype set as 0, use this command to set IP address of IP-300 IP

phone.

set subnetmask XXX.XXX.XXX.XXX

With iptype set as 0, use this command to set subnet mask of IP-300 IP

phone.

set router XXX.XXX.XXX.XXX

With iptype set as 0, use this command to set router IP of network with

37

Image 37

Contents Page Page Product Description Before Getting StartedFunction Keys of IP 300 IP Phone Introduction Normal State FeaturesHardware SoftwareOperating requirements Standard and ProtocolElectric requirements IP 300 IP Phone supports following standard and protocolSize Power 5 W maxConnecting the Handset and Cables What is the IP Addressing of your network?Page Enter setting mode Using the Keypad to Configure the IP phoneWhat if your network is using Dhcp Addressing? Page Enter the Local IP address What if your network is using Static IP Addressing ?202.67.240.221 Enter the subnetmask addressMenu Structure Page Page Using the Web Browser to configure the IP phone Network Setting Page Protocol settings Page Page Page Service id Voiptest.com Page Phone settings Page Page Audio settings Other settings Setting Page using ordinary pin with Debug set as 0 disable Phone Book Illustration Telnet Configuration Load designated settings to current position Save current settings to designated position Exit with saving all configurations and restart IP Detail description of IP 300 Telnet commands Command ?Will be displayed Detailed description Set iptype Command set Syntax description set keywords valueSet ppppin Set pppidSet ip Set subnetmaskSet service type Set nattraversal Set nataddrSet nattraversal Set serviceidSet phonenumber Set nat ttlSet account Set pinSet registerport Set signalportSet controlport Register ttlJitter sizeX Set rtpportSet localtype Set dtmfNumber. set dddcode Set dialnumberSet iddcode Set iddprefixSet innerline Set dddprefixSet localpreifx Set nonlocalprefixSet fwdnumber Set fwdpoweroffSet fwdalways Set fwdbusySet audioframes Set upgradeaddr Set passwordCommand store Relevant Usage store Command loadRelevant usage None Command write Relevant Usage load Command exitFtp command Syntax description ftp value Relevant usage ftp Call another IP 300 IP phone under the same Gatekeeper To place a callSpeed Dialing Receiving a CallStoring a Number into Memory Dial Dial a Stored NumberKeys Press Press Twice