Perfectone Net Ware IP 300 manual Set nat ttl, Set phonenumber, Set account, Set pin

Page 41

IP 300 User Manual

value with INNOPATH private system used; 4: stun. Use this value with

SIP protocol used according to requirement of system; 5: use this value

with vida private system used; 6: aivgr use this value with aivgr private

system used; 7 Eproxy: use Eproxy system.

Set nat ttl XX

When IP phone sit behind a NAT device, it will send packets to server every “nat ttl” seconds to keep the port mapping on the NAT device alive. “nat ttl” is an integer between 10 and 60, default value is 20.

set phonenumber XXXXXXXX

Set a number ofIP-300 IP phone according to systems. Value xxxxx must be an Arabic numeral and no longer than 16 characters.

set account XXXXXX

With H323 protocol used, while calling card is set, set account of chosen card; while local type is set as 2[H235 account] , set ID; while set localtype is set as 1, set H323 ID. With MGCP protocol used, please set local name by this command. With Net2phone system used, set account of Net2phone card by this command.

set pin XXXXXXXXXX

With H323 protocol used, while calling card is set, set password of chosen

41

Image 41
Contents Page Page Product Description Before Getting StartedFunction Keys of IP 300 IP Phone Introduction Normal State FeaturesHardware SoftwareOperating requirements Standard and ProtocolElectric requirements IP 300 IP Phone supports following standard and protocolSize Power 5 W maxConnecting the Handset and Cables What is the IP Addressing of your network?Page What if your network is using Dhcp Addressing? Using the Keypad to Configure the IP phoneEnter setting mode Page Enter the Local IP address What if your network is using Static IP Addressing ?202.67.240.221 Enter the subnetmask addressMenu Structure Page Page Using the Web Browser to configure the IP phone Network Setting Page Protocol settings  Page Page Page Service id Voiptest.com Page Phone settings Page Page Audio settings Other settings Setting Page using ordinary pin with Debug set as 0 disable Phone Book Illustration Telnet Configuration Load designated settings to current position Save current settings to designated positionExit with saving all configurations and restart IP Detail description of IP 300 Telnet commands Command ?Will be displayed Detailed description Set iptype Command set Syntax description set keywords valueSet ppppin Set pppidSet ip Set subnetmaskSet service type Set nattraversal Set nataddrSet nattraversal Set serviceidSet phonenumber Set nat ttlSet account Set pinSet registerport Set signalportSet controlport Register ttlJitter sizeX Set rtpportSet localtype Set dtmfNumber. set dddcode Set dialnumberSet iddcode Set iddprefixSet innerline Set dddprefixSet localpreifx Set nonlocalprefixSet fwdnumber Set fwdpoweroffSet fwdalways Set fwdbusySet audioframes Set upgradeaddr Set passwordCommand store Relevant Usage store Command loadFtp command Syntax description ftp value Relevant Usage load Command exitRelevant usage None Command write Relevant usage ftp Call another IP 300 IP phone under the same Gatekeeper To place a callSpeed Dialing Receiving a CallStoring a Number into Memory Dial Dial a Stored NumberKeys Press Press Twice