Trilogy Touch Technology 9 manual Commander Installation Guide

Page 72

Commander Installation Guide

8.5.4.2500-40-0x Series Control Panel Rear View

8.5.4.3Typical expansion panel configuration

Since the 500-3x-3x series panels (“Standard” 8 / 16 / 24 key) only have a single expansion connection, they must form either the first or last panel in a chain. Expansion panels from the 500-40 range have both Expansion In and Expansion Out connectors, allowing them to be connected in a chain. The PathFinder configuration software includes full expansion panel support (from version 4.12 onwards). This controls the sequence in which the panels should be added to the configuration editor and the electrical interconnection sequence. Obviously, the panels may be assembled into the control desk in any preferred positions, cable lengths permitting. Two different cable types are required, Type A and Type B which are detailed in section 8.5.4.4.

The following rules need to be observed when connecting expansion panels onto a system:

¾The standard series panels have only a single expansion port, used as “EXPANSION IN” or “EXPANSION OUT”. Therefore, these panels must be connected on the beginning or end of a chain only.

¾Standard control panels (500-3x series) used in expansion mode need the internal DIP switch 1 set to “ON”. If the panels are supplied as part of a pre-configured system, this will be carried out by Trilogy and the panels marked accordingly. See Section 10.1.

¾When a standard panel appears at the end of a chain, it must be connected using cable type B (see section 8.5.4.3).

¾The audio only operates on the first panel of the chain: if required, the microphone may be removed from the second “standard” panel. Trilogy can supply a blank plug for the microphone fixing.

¾The maximum suggested cable length for interlinking cables is 10 metres.

¾A maximum of 5 panels may be configured within PathFinder. The other controlling limits are either 63 keys or 63 rotary encoders – whichever is reached first.

A number of different arrangements are shown below; others are possible.

Page 72 of 81

Issue 9

Trilogy Communications Limited

Image 72

Contents Installation Guide Issue Date Reason for Change Approved Document Number50096601.doc Errata Sheet DescriptionContents Introduction Control Panels Legacy Hardware Options Available and Module Type Numbers Commander Installation Guide Issue Introduction UnpackingRack Mounting System Assembly 500-08-10 Changeover Module 1 500-08 Series Changeover CardCommander Installation Guide Commander Installation Guide 4 500-25-00 E1 Network Link Card 5 500-10 Series MISC. I/O GPI Cards6 500-06 Series Matrix Cards Mains Connection and Fusing 1 500-15-30 Series Power SupplyD9 Fixed Plug Pin Function XLR4 Fixed Socket Pin FunctionStarting the System Commander Installation Guide Connecting the Matrix Ports Connecting the PC to the Commander SystemConnection VIA a PC COM Port Using RS232 Connection VIA a 500-16-03 Download Converter BOX Sub D 9 free female Sub D 9 free maleSub D 9 free female Installing Pathfinder 574 not 576 for a six frame system Camera Connector Other Matrix ConnectionsMatrix Ports RJ-45 RS232 configuration RS422 configurationAlarms Serial Link RS232 / RS422Miscellaneous I/O Card Connector PIN-OUT Commander D37 Fixed Plug Pin DescriptionCommander D25 Fixed Socket Upper Connector Pins Description Commander D25 Fixed Socket Lower Connector Pins DescriptionCommander D9 Fixed Socket Pin Description 5.1 500-10 Switches and Indicators Suggested external wiring of Misc I/O card output 5.3 500-25 Network Card Indicators and Switches LEDConfiguring the Gain of Camera Inputs .5.1 Link Setting on Connecting Networked Systems 1 500-26 Network Rear Connector Unit RCUEither Serial Networking Commander Installation Guide Issue Current Range Control Panel Facility Comparison Table 500-41-XX Series Desktop Panels Specification 2 500-3X-5X Series Standard Control Panel Rear View Expansion Port RJ45 socketRJ-45 Function Pin Matrix and Expansion RJ45 socket view from rear of panelGpio Local logic in and out D9 Fixed Socket Audio I/O D15 Fixed SocketKeypad D9 Fixed Socket -51 variant only View of Keypad front panel4 500-3X-5X Series DIP Switch Settings OFFRear Connector Layout Rear Connecor Layout Connections Expansion out RJ-45 fixed socket on panelMatrix RJ-45 fixed socket on panel Gpio Local logic in and out D9 Fixed Socket Keypad D9 Fixed Socket View of Keypad as seen on front panelControl Panel Gpio External Circuitry Connector types 500-31-60 Standard Facility 16 KEY Control PanelRear Panel Layout Headset 5 Pin XLR Fixed Socket front panelGpio Local logic in and out D9 Fixed Socket 10 500-33-00 / 500-45-00 / 500-46-00 Range Gpio Local logic in and out D9 Fixed Socket Commander Installation Guide Issue Ttprog Software 6.2.1 SET-UP Routine Starting the Programme Connecting the Hardware 4.2 500-02-1x Talkback Controller4.3 500-3x-3x Control Panels Commander Programming Cable Way D Male Way D Female 4.4 500-08-10 Changeover CardProgramming with the 500-16-03 Download Converter Beltpacks RM15TPD-12SConnector Detail per channel Connector DetailTelephone Interfaces Trilogy 500-19-10 Telephone Interface FrameTelos ONE Alignment RT Equipment 500-22-00 ICIS-1 Isdn InterfaceIsdn Interface RJ45 Connector Com PortRemote Ports 1.5 RJ45500-23-00 ICIS-2 Isdn Interface D15 Fixed Plug on ICIS-2 DTEGain Setting on Matrix CardsPower Supplies Matrix DownloadComputer Operating Systems Important Note Installing AN Archipel Download Card in a P.C Commander Installation Guide Black BOX IC114A Pcmcia Serial Adaptor Card Matrix Ports D9 Legacy Control Panels Legacy Control Panel Facility Comparison Table2.1 500-3x-3x Series Standard Control Panel Rear View Test Port- D9 Fixed Socket Expansion Port- D9 Fixed Socket3 500-30 Series DIP Switch Settings Connector Pin Out Expansion In D9 Fixed Socket 4 500-40-0X Series Expansion PanelsExpansion Out- D9 Fixed Socket Commander Installation Guide Page Connecting VIA Structured Cabling Type B max length 10 metres D9 Free Plug Function PinD9 pin RJ 45 pin Colour see above 6.1 500-39-30 Connector Pin Out 6 500-39-30 / 31 1U 12 KEY Panel with Loudspeaker6.2 500-39-30 Rear View 7 500-3X-5X Series Control Panels8 500-43-51 1U, 8 REN Level Control Panel Matrix Audio Specification Using 500-06-02 Matrix Cards GeneralReal Time Performance PanelsMiscellaneous I/O Card P.C10.1 500-3X-5X Series Internal Panel Switch Settings 10.2 500-41 Desktop Panel Internal SettingsCut Switch Action No action 10.3 500-31-60 Programming CUT Switch Operation HSMic LSCut MCCut OffTest Function Safety Precautions Mains Connector and PlugLoop Back Test Mode Transportation and Storage