Trilogy Touch Technology 9 manual 5.3 500-25 Network Card Indicators and Switches, Led

Page 29

Commander Installation Guide

3.4.5.3500-25 Network Card Indicators and Switches

8 way DIP Switch

		LED	Legend	Activity	Function
		D8	+5V	On	+5V
	1	D1	1	1Hz	DSP 1 OK
		D2	2	2Hz	DSP 2 OK
		D6	RESET	Off	Reset
		D3	NO E1 CLK	Off if net available	No E1 Clock
		D9	TDM D	Off when started	TDM Disabled
		D10	1 DIS	Off when started	DSP Disabled (TDM)
		D11	BUSY	Quick flash	TDM Busy
		D12	COM1	Quick flash	DSP Comms (TDM)
		D13	E1 DIS	Off if data available	E1 Disabled
		D14	2 DIS	On when E1 down	NET DSP Disabled
	13	D14	2 DIS	On when E1 down	NET DSP Disabled
	13	D15	BUSY	On when buffers full	NET DSP Busy
		D15	BUSY	On when buffers full	NET DSP Busy
		D16	COM2	Unused	NET DSP Comms

		LED	Legend	Activity	Function
		D17	1	1Hz	DSP 1 & 2 sync’d
	Reset	D18	2	On when full	IN Buffer full
		D19	3	On when full	OUT Buffer full
	1	D20	4	On during start then off	E1 clk & event off
	1				command
					command
		D21	5	On	Possible RX Data loss
		D21	5	On	Possible RX Data loss
		D22	6	On if clk missing	E1 Clock off
		D22	6	On if clk missing	E1 Clock off
		D23	7	Normally toggles	Receiving H IP Data
	8	D24	8	Normally toggles	Transmitting H IP Data

DIP Switch Functions

Sw	Function	Default	Note
1	Cable Match	OFF=	ON = Co-ax
		CAT 5
2	Cable Length	ON =	OFF = “long”
		norm

3	undefined
4	undefined
5	undefined
6	UART IN	OFF
7	UART OUT	OFF
8	ERR CORR	OFF

•D1 and D2 will, under normal operation, flash at 1Hz and 2Hz respectively. If there is a problem during start-up, one or both LEDs will flash considerably faster.

•D13 should be on under normal operating conditions. The LED turns off when data comes in from a remote link but the off duration is very short and not visible. It is therefore only useful to show an error condition.

•D20 is turned on just after power-up then turned off under TDM control shortly afterwards. The LED is also on during a TDM reconfiguration process. The state of the LED is duplicated on a remote 500-25 if connected directly.

Trilogy Communications Limited

Issue 9

Page 29 of 81

Image 29

Contents Installation Guide 50096601.doc Issue Date Reason for Change ApprovedDocument Number Description Errata SheetContents Introduction Control Panels Legacy Hardware Options Available and Module Type Numbers Commander Installation Guide Issue Rack Mounting IntroductionUnpacking System Assembly 1 500-08 Series Changeover Card 500-08-10 Changeover ModuleCommander Installation Guide Commander Installation Guide 5 500-10 Series MISC. I/O GPI Cards 4 500-25-00 E1 Network Link Card6 500-06 Series Matrix Cards 1 500-15-30 Series Power Supply Mains Connection and FusingD9 Fixed Plug Pin Function XLR4 Fixed Socket Pin FunctionStarting the System Commander Installation Guide Connection VIA a PC COM Port Using RS232 Connecting the Matrix PortsConnecting the PC to the Commander System Sub D 9 free female Connection VIA a 500-16-03 Download Converter BOXSub D 9 free female Sub D 9 free male Installing Pathfinder 574 not 576 for a six frame system Matrix Ports RJ-45 Camera ConnectorOther Matrix Connections RS422 configuration RS232 configurationAlarms Serial Link RS232 / RS422Commander D37 Fixed Plug Pin Description Miscellaneous I/O Card Connector PIN-OUTCommander D9 Fixed Socket Pin Description Commander D25 Fixed Socket Upper Connector Pins DescriptionCommander D25 Fixed Socket Lower Connector Pins Description 5.1 500-10 Switches and Indicators Suggested external wiring of Misc I/O card output LED 5.3 500-25 Network Card Indicators and SwitchesConfiguring the Gain of Camera Inputs .5.1 Link Setting on 1 500-26 Network Rear Connector Unit RCU Connecting Networked SystemsEither Serial Networking Commander Installation Guide Issue Current Range Control Panel Facility Comparison Table 500-41-XX Series Desktop Panels Specification Expansion Port RJ45 socket 2 500-3X-5X Series Standard Control Panel Rear ViewRJ-45 Function Pin Matrix and Expansion RJ45 socket view from rear of panelAudio I/O D15 Fixed Socket Gpio Local logic in and out D9 Fixed SocketKeypad D9 Fixed Socket -51 variant only View of Keypad front panelOFF 4 500-3X-5X Series DIP Switch SettingsRear Connector Layout Matrix RJ-45 fixed socket on panel Rear Connecor Layout ConnectionsExpansion out RJ-45 fixed socket on panel Gpio Local logic in and out D9 Fixed Socket Control Panel Gpio External Circuitry Keypad D9 Fixed SocketView of Keypad as seen on front panel 500-31-60 Standard Facility 16 KEY Control Panel Connector typesRear Panel Layout Headset 5 Pin XLR Fixed Socket front panelGpio Local logic in and out D9 Fixed Socket 10 500-33-00 / 500-45-00 / 500-46-00 Range Gpio Local logic in and out D9 Fixed Socket Commander Installation Guide Issue Ttprog Software 6.2.1 SET-UP Routine Starting the Programme 4.3 500-3x-3x Control Panels Connecting the Hardware4.2 500-02-1x Talkback Controller Programming with the 500-16-03 Download Converter Commander Programming Cable Way D Male Way D Female4.4 500-08-10 Changeover Card RM15TPD-12S BeltpacksConnector Detail Connector Detail per channelTelephone Interfaces Trilogy 500-19-10 Telephone Interface FrameTelos ONE Alignment 500-22-00 ICIS-1 Isdn Interface RT EquipmentCom Port Isdn Interface RJ45 ConnectorRemote Ports 1.5 RJ45D15 Fixed Plug on ICIS-2 DTE 500-23-00 ICIS-2 Isdn InterfaceMatrix Cards Gain Setting onComputer Operating Systems Important Note Power SuppliesMatrix Download Installing AN Archipel Download Card in a P.C Commander Installation Guide Black BOX IC114A Pcmcia Serial Adaptor Card Matrix Ports D9 Legacy Control Panel Facility Comparison Table Legacy Control Panels2.1 500-3x-3x Series Standard Control Panel Rear View Expansion Port- D9 Fixed Socket Test Port- D9 Fixed Socket3 500-30 Series DIP Switch Settings Expansion Out- D9 Fixed Socket Connector Pin Out Expansion In D9 Fixed Socket4 500-40-0X Series Expansion Panels Commander Installation Guide Page D9 pin RJ 45 pin Colour see above Connecting VIA Structured CablingType B max length 10 metres D9 Free Plug Function Pin 6 500-39-30 / 31 1U 12 KEY Panel with Loudspeaker 6.1 500-39-30 Connector Pin Out8 500-43-51 1U, 8 REN Level Control Panel 6.2 500-39-30 Rear View7 500-3X-5X Series Control Panels General Matrix Audio Specification Using 500-06-02 Matrix CardsReal Time Performance PanelsP.C Miscellaneous I/O CardCut Switch Action No action 10.1 500-3X-5X Series Internal Panel Switch Settings10.2 500-41 Desktop Panel Internal Settings Test Function 10.3 500-31-60 Programming CUT Switch OperationHSMic LSCut MCCut Off Mains Connector and Plug Safety PrecautionsLoop Back Test Mode Transportation and Storage