Trilogy Touch Technology manual 6 500-39-30 / 31 1U 12 KEY Panel with Loudspeaker

Commander Installation Guide

8.5.6500-39-30 / 31 1U 12 KEY PANEL WITH LOUDSPEAKER

This panel provides more basic facilities than the 500-30 range. It does not have LCD displays and only provides connection to the matrix, audio I/O and the test port at the rear. An installation specification is given below.

Dimensions	485mm wide x 44.5mm high x 150mm deep
	(excluding connectors) 200m approx. (including
	mating connectors)
	19” x 1RU rack mounting
Mains Input	90 – 260 V ac, 50-60Hz
Current Consumption	150mA @ 90V ac, 50mA @ 250V ac.

8.5.6.1 500-39-30 Connector Pin Out

Matrix – D9 Fixed Plug

Pin	Function
1	NC (Screen)
2	Data Out-
3	Data In-
4	Audio Out-
5	Audio In-
6	Data Out +
7	Data In +
8	Audio Out +
9	Audio In +

Audio I/O – D15 Fixed Socket

Test– D9 Fixed Socket

Pin Function

1Analyse Input

2Enable Remote Boot

3Ground

4Transputer Link Out +

5Transputer Link In +

6Error signal Out

7Reset In

8Transputer Link Out-

9Transputer Link In-

Headset - 5 Pin XLR Fixed Socket (front panel)

Pin	Function
1	Mic IN (Screen)
2	Mic IN
3	Headset Gnd
4	Headset Out
5	Headset Out

Pin	Function	Notes
1	Slave Mic Input	Line level, un-balanced
2	+15V Out (for slave mic panel)	NOT protected!
3	Clean Mic Out +	Line level, balanced, pair with 11
4	Ext CUT Input (for slave mic panel)	Parallel function to front panel Cut
5	Chassis Ground	Switch. Ground to activate
6	No connection
7	External Input to LS Amp -	Line level, balanced, pair with 14
8	Matrix Audio Input to Panel / parallel output -	Line level, balanced, pair with 15
9	Ext Mic Cut output (to slave panel)	Normally grounded. O/P is open
		circuit when front panel cut selected.
10	-15V Out (for Slave mic panel)	NOT protected
11	Clean Mic Out -	Line level, balanced, pair with 3
12	Mic Ground
13	Loudspeaker Output	8 ohm loudspeaker
14	External Input to LS Amp +	Line level, balanced, pair with 7
15	Matrix Audio Input to Panel / parallel output +	Line level, balanced, pair with 8

NB 15V supplies are also used to derive 12V for panel. (Thermally Fused @ 0.7A)

The 500-39-31panel includes an additional expansion connector, logic GPIO signals and footswitch connector in the same format as the 500-3x-3x series expansion panels. It is only available to special order. See section 8.5.2.2 for connector details.

Trilogy Communications Limited Issue 9 Page 75 of 81