Trilogy Touch Technology 9 manual Isdn Interface RJ45 Connector, Com Port, Remote Ports, 1.5 RJ45

Page 59

Commander Installation Guide

7.4.1.2ISDN Interface RJ45 Connector

RJ45 Fixed Socket

Pin 1

Not connected

 

Pin 2

Not connected

 

Pin 3

Tx to network A/Rx from terminal A

 

Pin 4

Rx from network A/Tx to terminal A

 

Pin 5

Rx from network B/Tx terminal B

 

Pin 6

Tx to network B/Rx from terminal B

 

Pin 7

Not connected

 

Pin 8

Not connected

7.4.1.3Com Port

D9, not yet supported, for future development.

7.4.1.4Remote Ports

Each input is the cathode of the LED on an opto-isolator. The anode is connected through a 470R resistor to +5VDC. Therefore to activate a control input, short the pin to ground, i.e. pin

10.Each output is the open collector of a ULN2003 driver chip. Therefore connect the pin through load to +5VDC.

7.4.1.5RJ45

This is the ISDN 2 connector. This must only be connected to an approved ISDN 2 connection or serious damage may occur.

Trilogy Communications Limited

Issue 9

Page 59 of 81

Image 59
Contents Installation Guide 50096601.doc Issue Date Reason for Change ApprovedDocument Number Description Errata SheetContents Introduction Control Panels Legacy Hardware Options Available and Module Type Numbers Commander Installation Guide Issue Rack Mounting IntroductionUnpacking System Assembly 1 500-08 Series Changeover Card 500-08-10 Changeover ModuleCommander Installation Guide Commander Installation Guide 5 500-10 Series MISC. I/O GPI Cards 4 500-25-00 E1 Network Link Card6 500-06 Series Matrix Cards XLR4 Fixed Socket Pin Function Mains Connection and Fusing1 500-15-30 Series Power Supply D9 Fixed Plug Pin FunctionStarting the System Commander Installation Guide Connection VIA a PC COM Port Using RS232 Connecting the Matrix PortsConnecting the PC to the Commander System Sub D 9 free female Connection VIA a 500-16-03 Download Converter BOXSub D 9 free female Sub D 9 free male Installing Pathfinder 574 not 576 for a six frame system Matrix Ports RJ-45 Camera ConnectorOther Matrix Connections Serial Link RS232 / RS422 RS232 configurationRS422 configuration AlarmsCommander D37 Fixed Plug Pin Description Miscellaneous I/O Card Connector PIN-OUTCommander D9 Fixed Socket Pin Description Commander D25 Fixed Socket Upper Connector Pins DescriptionCommander D25 Fixed Socket Lower Connector Pins Description 5.1 500-10 Switches and Indicators Suggested external wiring of Misc I/O card output LED 5.3 500-25 Network Card Indicators and SwitchesConfiguring the Gain of Camera Inputs .5.1 Link Setting on 1 500-26 Network Rear Connector Unit RCU Connecting Networked SystemsEither Serial Networking Commander Installation Guide Issue Current Range Control Panel Facility Comparison Table 500-41-XX Series Desktop Panels Specification Matrix and Expansion RJ45 socket view from rear of panel 2 500-3X-5X Series Standard Control Panel Rear ViewExpansion Port RJ45 socket RJ-45 Function PinView of Keypad front panel Gpio Local logic in and out D9 Fixed SocketAudio I/O D15 Fixed Socket Keypad D9 Fixed Socket -51 variant onlyOFF 4 500-3X-5X Series DIP Switch SettingsRear Connector Layout Matrix RJ-45 fixed socket on panel Rear Connecor Layout ConnectionsExpansion out RJ-45 fixed socket on panel Gpio Local logic in and out D9 Fixed Socket Control Panel Gpio External Circuitry Keypad D9 Fixed SocketView of Keypad as seen on front panel Headset 5 Pin XLR Fixed Socket front panel Connector types500-31-60 Standard Facility 16 KEY Control Panel Rear Panel LayoutGpio Local logic in and out D9 Fixed Socket 10 500-33-00 / 500-45-00 / 500-46-00 Range Gpio Local logic in and out D9 Fixed Socket Commander Installation Guide Issue Ttprog Software 6.2.1 SET-UP Routine Starting the Programme 4.3 500-3x-3x Control Panels Connecting the Hardware4.2 500-02-1x Talkback Controller Programming with the 500-16-03 Download Converter Commander Programming Cable Way D Male Way D Female4.4 500-08-10 Changeover Card RM15TPD-12S BeltpacksTrilogy 500-19-10 Telephone Interface Frame Connector Detail per channelConnector Detail Telephone InterfacesTelos ONE Alignment 500-22-00 ICIS-1 Isdn Interface RT Equipment1.5 RJ45 Isdn Interface RJ45 ConnectorCom Port Remote PortsD15 Fixed Plug on ICIS-2 DTE 500-23-00 ICIS-2 Isdn InterfaceMatrix Cards Gain Setting onComputer Operating Systems Important Note Power SuppliesMatrix Download Installing AN Archipel Download Card in a P.C Commander Installation Guide Black BOX IC114A Pcmcia Serial Adaptor Card Matrix Ports D9 Legacy Control Panel Facility Comparison Table Legacy Control Panels2.1 500-3x-3x Series Standard Control Panel Rear View Expansion Port- D9 Fixed Socket Test Port- D9 Fixed Socket3 500-30 Series DIP Switch Settings Expansion Out- D9 Fixed Socket Connector Pin Out Expansion In D9 Fixed Socket4 500-40-0X Series Expansion Panels Commander Installation Guide Page D9 pin RJ 45 pin Colour see above Connecting VIA Structured CablingType B max length 10 metres D9 Free Plug Function Pin 6 500-39-30 / 31 1U 12 KEY Panel with Loudspeaker 6.1 500-39-30 Connector Pin Out8 500-43-51 1U, 8 REN Level Control Panel 6.2 500-39-30 Rear View7 500-3X-5X Series Control Panels Panels Matrix Audio Specification Using 500-06-02 Matrix CardsGeneral Real Time PerformanceP.C Miscellaneous I/O CardCut Switch Action No action 10.1 500-3X-5X Series Internal Panel Switch Settings10.2 500-41 Desktop Panel Internal Settings Test Function 10.3 500-31-60 Programming CUT Switch OperationHSMic LSCut MCCut Off Transportation and Storage Safety PrecautionsMains Connector and Plug Loop Back Test Mode