Polycom 8020, 8030, 1725-36038-001 manual Proxy server commands, Parameter Value Description

Programming the SIP Handset Features

Proxy server commands

Use the following parameters when programming the configuration files. See the sample configuration files following this table for more detailed information.

Parameter	Value	Description	Notes
PROXYn_ADDR	xxx.xxx.xxx.xxx:pppp	Proxy address.	n = 1, 2, 3
	or		xxx.xxx.xxx.xxx = IP4 address
			pppp = port (optional, 5060 is the
			default)
	proxyname:pppp		proxyname = computer name
			(DHCP only)
PROXYn _DOMAIN	Domain name	Domain served by this	n = 1, 2, 3
		proxy server.	DOMAIN = [example:
			spectralink.com]
			Can be omitted if the proxy does
			not act as a domain server.
PROXYn_TYPE	Inter-Tel	Specify the	Used by the handset to perform
	SER	manufacturer of each	proxy-specific actions based on
		defined proxy server.	known behavior for specific proxy
	Asterisk2
			types. Only the three shown
			values may be used. Omit this
			parameter if the value is not one
			of these recognized settings.
PROXYn_	enable	Controls generation of	n = 1, 2, 3
KEYPRESS_2833	disable	in-stream RFC2833
		formatted key press
		events.
PROXYn_	enable	Controls generation of	n = 1, 2, 3
KEYPRESS_INFO	disable	SIP INFO requests to
		the SIP server for
		keypress events.
PROXYn_HOLD_IP0	enable	Controls setting of the	n = 1, 2, 3
	disable	media stream IP	Use for compatibility with older
		destination address to
			SIP servers that may not
		0 (zero) when a call is	recognize newer stream attribute
		put on hold.
			parameters for HOLD status.

2For up-to-date Asterisk voicemail commands, go to:

http://www.voip-info.org/wiki/index.php?page=Asterisk+cmd+VoiceMailMain

PN: 1725-36038-001_B.doc 51