Polycom 8020, 8030 manual Startup Sequence, Icon Icons shown in bold turns off when, Registering

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP

Startup Sequence

			The SpectraLink 8020/8030 Wireless Telephone goes through an
			initialization sequence at startup. The line icons 1-9 display and count
			down as the handset steps through this sequence. This is usually very
			rapid. If there is difficulty at any step that prevents initialization from
			continuing, an error message will display and the related icon(s) will
			stay on. Please see the error table at the back of this document for
			instructions on how to handle error messages that occur during
			initialization.
	Icon		The icon(s) shown in bold turns off when:
123456789			The handset has located and authenticated and associated with at least one AP, and is
			proceeding to bring up higher-layer networking functions.
12345678			The handset is either configured for Static IP, or if configured for DHCP, the DHCP
			discovery process has started.
1234567			If DHCP is configured, a DHCP response was received which contains a good DNS
			server configuration.
123456		Note: Only valid on non-SRP protocol. Indicates one of the following:
		Static IP configuration, or
		SpectraLink 8000 SVP Server address found in DHCP response, or
		SpectraLink 8000 SVP Server address found via DNS lookup.
12345			All networking functions are complete (notably, DHCP), and the handset is proceeding
			with establishing the SRP link to the SpectraLink 8000 SVP Server.
1234			The SRP link is established; all network stack initialization is complete, proceeding with
			application-specific initialization.
123			SIP application startup. Icon 3 is extinguished if a generic SIP config file is found.
12			Icon 2 is extinguished if a handset specific SIP config file is found.
	(no icons)		Handset is attempting to register each of the specified line contacts.
	Registering
	(no icons)		Handset has registered with at least one contact on one proxy server. Initialization is
	EXT.
			complete. The handset is in standby mode ready to receive and place calls. The line one
	XXXXX
			contact is displayed.

18 PN: 1725-36038-001_B.doc