Aiphone FK1629 B 0811YZ Registering stations System setting Registering stations, Other buttons

Page 20

Registering stations

[System setting – Registering stations]

Register all the stations connected in the system, and set the area, station no. and station name to them.

1 Click Registering stations in the table of contents.

2 Set the area, station no. and station name to the target stations.

*Setting the station no. is required to register the station to the system.

*For a cell with the mark, select the target one from the pull-down menu.

*Do not set stations with the same number in an area.

NOTE:

The name of a master station displayed on its monitor in standby mode is up to 16 alphanumeric characters.

Other buttons

Connection check

Click to confirm the connected units.

Connected: yellowish green

Not connected: gray

Station type error: pink

[Collective setting]:

The following buttons are used to make the settings to all the checked stations at one time.

*Pressing each button opens another window.

NOTE:

Be sure to check all the target stations before using these buttons.

Area

Click to set the same area number to all the checked stations.

Station number

Click to assign sequential numbers to all the checked stations from top to bottom. The number you enter will be set as the first number and will be assigned to the top station of the ones checked. Other checked stations will be numbered sequentially.

Station name

Click to assign the same station name and sequential numbers to all the checked stations from the top down. Enter a name only.

Station type

(Not available in a network direct system.)

How to select multiple stations

Click to check the stations you will register.

By clicking the button on the top of the list, you can check or cancel all the stations on the list.

3 Click Temporarily stored to save the current setting results temporarily.

*If you wish to cancel the setting results you have made, click a title in the table of contents or “Refresh” in the web browser menu.

20

Image 20
Contents Setting Manual Contents Manual configurations Purpose of the System SettingsAbout this Manual Setting List Title Sub title Sub item Setting range DefaultDT1/DT2 NTP Call Priority System Setting Flow From the chart below, then start the network settings byGo to P First selectFlow For each IP client unit All units Static IP addresses are setFor the IP host unit Started Setting the System Using the System Remote site connection settings ProcedureWhen connecting a PC to the IP unit via a hub switch When connecting a PC to the IP unit directlySystem requirements for PC Connect a PC to the IP unitTurn on the power to the IP unit Log in to the system by setting the following itemsPassword Enter aiphone Go to the nextSystem Setting Details Basic setting procedureClick Network setting Individual in the table Click Network setting Common in the tableRepeat to 5 to make settings to other IP units Close the windowRegistering zones System setting Zone registration RequiredCheck the boxes for the IP units you want to register Registering IP units System setting IP unit registrationClick IP unit registration in the table of contents Registering stations System setting Registering stations How to select multiple stationsCollective setting Other buttonsBasic setting procedure Making detailed settings to door stationsClick Advanced station settings in the table of contents When you have finished making all the detailed settingsMaking detailed settings to master stations Settings on Other windowSettings on Stations to be scan monitored window About the priorityRegistering stations to zones System setting Zone setting Check to select the target stationsClick Close after you have finished selecting the stations Click Registering daily transfer scheduleSettings on Individual schedule setting window Click Transfer schedule setting in the table of contentsSettings on Weekly schedule setting window Setting the timer Timer setting Click Remote site pilot call setting in the table Settings on Remote site master call setting windowSettings on Remote site door call setting window Settings on Remote site paging setting windowSetting time and date Time and date setting Downloading/uploading setting data Setting file When downloading setting data onto the PCWhen uploading setting data Click Downloading setting data in the table of contentsMaintenance Setting Information Memo