Programming
Special programming
Night mode
Night mode allows you to select a period of time during which the handset and/or base unit will not ring for outside calls. This feature is useful for time periods when you do not want to be disturbed, for example, while sleeping. Night mode can be set independently for each handset and base unit.
Important:
L Set the date and time beforehand (page 16). L Handset only: If you have set the alarm, the alarm sounds even if the night mode is turned
on.
Setting the start and end time
YHandset / [ Base unit
1{MENU} i{#}{2}{3}{7}
2Enter the desired hour and minute you wish to start this feature.
3Press {*} to select “AM” or “PM”. i{OK}
4Enter the desired hour and minute you wish to end this feature.
5Press {*} to select “AM” or “PM”. i{OK}
6Proceed with the operation for your unit. Handset: {OFF}
Base unit: {■} (EXIT)
Note:
L To correct a digit:
Handset: Press {<} or {>} to move the cursor to the digit, then make the correction.
Base unit: Press {7} or {8} to move the cursor to the digit, then make the correction.
Turning night mode on/off
YHandset / [ Base unit
1{MENU} i{#}{2}{3}{8}
2{V}/{^}: “On” or “Off” i{SAVE}
3Proceed with the operation for your unit. Handset: {OFF}
Base unit: {■} (EXIT)
Note:
L When the night mode is turned on, 3is displayed.
Alarm
An alarm sounds at the set time for 3 minutes once or daily. Alarm can be set for each handset.
Important:
L Set the date and time beforehand (page 16).
YHandset
1{MENU} i{#}{7}{2}{0}
2{V}/{^}: Select the desired alarm option. i
{SELECT}
Off | Turns alarm off. Go to step 6. |
Once | An alarm sounds once at the set |
| time. |
Daily | An alarm sounds daily at the set |
| time. Go to step 4. |
3Enter the desired month and date.
4Set the desired time. i{OK}
5{V}/{^}: Select the desired ringer tone. i
{SELECT}
L We recommend selecting a ringer tone different from the ringer tone set for outside calls.
6{SELECT} i{OFF}
L When the alarm is set, Eis displayed.
Note:
L To stop the alarm, press any dial key or place the handset on the base unit or charger.
L When the handset is in use, the alarm will not sound until the handset is in standby mode.
LIf you select “Once”, the setting changes to “Off” after the alarm sounds.
L The ringer volume for alarm follows the higher volume level of the 2 lines (page 30).
LWhen the ringer volume for outside calls of the 2 lines is set to off (page 30), the alarm sound is heard at the low level.
32 | For assistance, please visit http://www.panasonic.com/help |