Preparation
1Press the notch on the handset cover firmly and slide it in the direction of the arrow.
2Remove the old batteries positive (S) end first and install the new ones. See page 10 for battery installation.
Turning the power on/off
Power on
Press {ih} for about 1 second.
L The display will change to the standby mode.
Power off
Press {ih} for about 2 seconds. L The display will go blank.
Setting dialling mode (tone/pulse)
Change the dialling mode depending on your telephone line service.
“Tone”: Select when you have a touch tone service.
“Pulse”: Select when you have rotary or pulse service.
1Press {j/OK}.
2Select “Base Unit Setup”, then press {>}.
3Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page 35).
4Select “Call Options”, then press
{>}.
5Select “Dial Mode”, then press {>}.
6Select the desired setting, then press
{>}.
7Press {ih}.
Setting the date and time
Important:
L Confirm that the AC adaptor is connected. L Ensure that w is not flashing.
1Press {j/OK}.
2Select “Handset Setup”, then press
{>}.
3Select “Time Settings”, then press
{>}.
4Select “Set Date & Time”, then press
{>}.
5Enter the current day, month and year by selecting 2 digits for each.
Example: 17 May, 2006 Press {1}{7} {0}{5} {0}{6}.
6Enter the current hour and minute by selecting 2 digits for each.
L You can select “AM”, “PM” or
Example: 3:30 PM
Press {0}{3} {3}{0}, then press {*} repeatedly until “03:30 PM” is displayed.
7Press {j/OK}.
8Press {ih}.
Note:
L To correct a digit, press {<} or {>} to move the cursor, then make the correction.
12