Panasonic KX-TG9392 Connecting the telephone line cord, To connect to a 2-line telephone jack

Preparation

Connecting the telephone line cord

Refer to one of the following methods depending on your situation:

–To connect to a 2-line telephone jack: page 13

–To connect to 2 single-line telephone jacks: page 13

–If you use the unit as a single-line telephone only: page 13

Connect the telephone line cord until it clicks into the base unit and telephone line jack.

To connect to a 2-line telephone jack

“GREEN” plug

4-wire cord

To 2-line telephone jack (RJ14C)

To connect to 2 single-line telephone jacks

	To single-line
“Transparent” plug	telephone jacks (RJ11C)
	2-wire cord
	Line 1
“GREEN” plug	4-wire cord
	Line 2

If you use the unit as a single-line telephone only

Be sure to connect the telephone line cord to LINE 1/2 to allow usage of the unit during a power failure (page 12). Change the line selection mode from “Auto” to “Line1” (page 17).

“Transparent” plug

2-wire cord

To single-line telephone jack (RJ11C)

Note:

L “Check tel line 2” is displayed on the unit. To erase it, see page 47.

For assistance, please visit http://www.panasonic.com/help 13