EXP1240 System Installation Guide | Revision 06 |
1)Connect a standard Ethernet cable (Cat 5 or higher) to the Ethernet/PoE jack on the rear of the base station. Route the cable through the channel as shown below.
Figure 3 Connecting the base station
2) Connect the other end of the cable to your TCP/IP network.
When the base station powers on, the STATUS LED on the front briefly lights orange and then turns off while it initializes and connects to the network. After the base station successfully initializes and connects to the network, the LED lights green and remains steady on.
Table 3: Base station LEDs and their meanings
Color | State | Meaning | |
|
|
| |
Green | Flickering | Firmware update in progress | |
|
|
| |
Green | Steady on | All operations normal. | |
|
|
| |
|
| No power in unit | |
(NA) | Off | OR | |
|
| Initializing and connecting to the network. |
Orange
Briefly on
Powering on
Orange
Flickering
Firmware update in progress
© 2013 Uniden America Corp. | PROPRIETARY AND CONFIDENTIAL | Page 11 of 71 |