Uniden EXP1240 manual Configuring Base Stations at Level 2 and Up

Page 36

EXP1240 System Installation GuideRevision 06

Figure 27: Base Station Group table, Level 1 complete (Multi-cellscreen)

Configuring Base Stations at Level 2 and Up

1)Place the first Level 2 base station at its final location. (See the Network Planning Guide for information on the proper placement of base stations.)

2)Login to the base station.

3)Reset the base station to its default settings (open the Management screen and click Default Base Station). If this base station has never been configured, skip this step.

4)Go to the Multi-cellscreen and set the Multi cell system field to Enable.

5)Enter the System chain ID and select a Multi Cell debug setting only if necessary.

6)Click Save and reboot the base station.

7)Allow several minutes for the base station to reboot, then go back to Multi-cellscreen and check the Base Station Group table.

© 2013 Uniden America Corp.

PROPRIETARY AND CONFIDENTIAL

Page 36 of 71

Image 36
Contents EXP1240 SIP Dect System Installation Guide Revision 06, July 7Contents Appendix a Software Reference Table of Figures List of Tables Dect system settings parameters Important Safety Instructions Check the Box ContentsAbout This Document Purpose and AudienceManual Conventions Terms used in this manualTerms AbbreviationsHardware Setup Base StationConnecting the base station Base station LEDs and their meaningsBase mounting dimensions Wall mounting the base stationHandset and Charger Handset front viewCharging the battery Powering on the HandsetInitial System Configuration Using the Base Station Interface Summary Basic system configurationConfiguring General System Settings Home/Status screenChange Configuration and Management Settings Management screenChange the Default Password Change the Pstn Tones and Emergency DialingConfigure the Network Settings Screen Country screenConfigure Time Settings Time Settings screenConfiguring the SIP Server Settings Checking time settings updatesSelecting YES indicates If information in rport and received Program the SIP Extensions To edit an existing serverTo delete a server Add Extension screen Register Handsets to Extensions To edit an extensionTo delete extensions Extensions screen, no handsets registered To deregister a handset Extensions screen, three handsets registeredIntroduction Timing LevelsSystem Chain ID and RPN Sample multi-cell system Setting Up a Multi-cell System Summary Multi-cell system configurationSample multi-cell system information Configuring the Primary Base Station Multi-cellscreen default valuesConfiguring Level 1 Base Stations Home/status screen primary base enabledMulti-cellscreen top after configuration EXP1240 System Installation Guide Configuring Base Stations at Level 2 and Up Base Station Group table, Level 1 complete Multi-cellscreenRemoving Base Stations from a Multi-Cell System Base Station Group table, Level 2 added Multi-cellscreenChanging the Primary Base Station in a Chain Multi cell Ready Keep-alive Primary Backing Up Configuration Settings Configuration screenRestoring a Configuration Setting Up Firmware FoldersUpdating the Firmware Configuring the Firmware Update Settings Firmware path examplesFirmware Update screen Updating Base Station FirmwareUpdating Handsets To verify the firmware update Firmware update progress Extensions screenBase Station Configuration Interface Available ScreensGlobal Buttons and Options Home/Status Screen Read Only Home/Status OptionsHome/Status parameters Extensions Screen Extensions optionsAdd Extension and Edit Extension screens Extensions parameters read onlyParameter Description Extension Servers Screen Servers optionsServers parameters SIP server outbound proxy address. Use one of these formats IP Settings parameters Network ScreenVlan Settings parameters Dhcp Options parametersNAT Settings parameters SIP/RTP Settings parametersManagement Settings parameters Management ScreenSetting. The intended audience is Level 1 or 2 technical Firmware Update Screen Firmware Update screen optionsUpdate Handsets parameters Time Settings parameters Time ScreenDST Country Screen Web Security ScreenCentral Directory Screen Multi Cell Screen Importing a new file will replace the existing contact listSettings for this unit parameters 71 for details Base Station Group parameters RPN DectConfiguration Screen read only Syslog Screen read only SIP Log Screen read only Appendix B Rfpi Numbers