Haier AC24CS1ERA, AC18CS1ERA Cleaning the Air Filter Open the Intake Grill, Clean the Air Filters

Page 10

Cleaning and Care

CAUTION:

Before cleaning the air conditioner, be sure to turn it off and disconnect the Power Supply Cord.

Be sure the Intake Grill is installed securely.

When removing and replacing the air filters, be sure not to touch the heat exchanger, or personal injury may result.

Cleaning the Air Filter

1. Open the Intake Grill

Pull out both sides and the center of the Intake Grill.

2. Pull the Air Filters upward to remove them

Push the Air Filter handles away from the Intake Grille in the direction as illustrated, then pull out Air Filters.

3. Clean the Air Filters

Remove the dust from the Air Filters by vacuum cleaner or washing them. After washing, allow the Air Filters to dry thoroughly in an area protected from sunlight.

4. Re-attach the Air Filters to the Intake Grill

(1)The Filters fit onto the inside of the intake Grill.(Figure 1) (2)The bottom edges of the Air Filters should fit into the filter brackets. (Figure 1)

(3)The Air Filters should be pushed down so that their top edges fit under the projections at the top of the Intake Grill. (Figure 2)

5. Close the intake grill

Push in both sides and the center of the Intake Grill.

About 30 mm

Side Panel

 

Hook

 

Notch

 

Arm

Arm Intake Grill

 

 

Air Filter

 

Bracket

 

Base

Air Filter

Handle

(Figure 1)

(Figure 2)

 

Filter bracket

 

Dust can be cleaned from the Air Filter either with a vacuum cleaner, or by washing the filter in a solution of mild detergent and warm water. If you wash the filter, be sure to allow it to dry thoroughly in a shady place before reinstalling.

If dirt is allowed to accumulate on the Air Filter, air flow will be reduced, operating efficiency lowers and noise increases. During periods of normal use, the Air Filters should be cleaned every two weeks.

Operation Tips

Instructions relating to heating are applicable only to "HEAT & COOL TYPE"

Heating Performance

This air conditioner operates on the heat-pump principle, absorbing heat from outdoor air and transferring that heat indoors. As a result, the operating performance is reduced as outdoor air temperature drops. If you feel that insufficient heating perfomance is being produced, we recommend you use this air conditioner in conjunction with another kind of heating appliance.

Heat-pump air conditioners heat your entire room by recirculating air throughout the room, with the result that some time may be required after first starting the air conditioner until the room is heated.

Microcomputer-controlled Automatic Defrosting

When using the Heating mode under conditions of low outdoor air temperature high humidity, frost may form on the outdoor unit, resulting in reduced operating performance.

In order to prevent this kind of reduced performance, this unit is equipped with a Microcomputer-controlled Automatic Defrosting function. If frost forms, the air conditioner will temporarily stop, and the defrosting circuit will operate briefly (for about 7 to 15 minutes).

8

Page 9 Page 11
Image 10
Page 9 Page 11
Contents AC12CS1ERA AC18CS1ERA AC24CS1ERA Page Contents Page Disposal of the old air conditioner Safety Instructions and WarningsSpecifications Disposal of the packaging of your new air conditionerSafety Precautions Fan only function Operation Both of the two positions are null Pull the Air Filters upward to remove them Cleaning the Air Filter Open the Intake GrillClean the Air Filters Re-attach the Air Filters to the Intake GrillAir conditioner wont start Followings are not problemsPoor cooling or heating Poor cooling FEHH@9B G8HEDHDecide the mounting position with the customer as follows Connect earthing wireWiring Use discharge pipe correctly to ensure efficient DischargeRemove the intake grill Installing drain hoseFloor Console Type 1.Drilling for piping Drilling holes for anchor bolts and installing Anchor bolts Drilling for pipingInstalling indoor unit Installing bracketsInstalling the drain hose Flare processing For strand wiring Fig.BFix connection cord and power cable at the cord clamp Bending pipesWiring of indoor unit Remove the electrical component boxMount the intake grill Mount the cover plate rightMount the cover plate left Check items 1. Indoor unitPage Page Page Contenido Información Importante ACER- CA DEL Refrigerante Utilizado Eliminación del embalaje de su nuevo aire acondicionado PrecaucionesEliminación de su antiguo aparato de aire acondicionado Instrucciones y advertencias de seguridad¡ADVERTENCIA Precauciones de seguridadComponentes y funciones ¡PELIGRO Mando a distancia  Instalación de las pilas Funcionamiento  Funcionamiento básico Uso del temporizador de encendido/apagado Consejos de utilización Limpieza y mantenimientoPrecaución El aparato de aire acondicionado no se inicia Resolución de problemasLas situaciones siguientes no constituyen problemas Mala refrigeración o calefacciónRefrigeración insuficiente Resolución de problemasMotivos Posibles Cableado Procedimiento de instalaciónAdvertencia UbicaciónTipo DE Consola DE Suelo 1. Taladrado para los tubos NotaInstalar la manguera de desagüe Taladrar orificios para los pernos de anclaje e instalar Tipo Bajo TechoTaladrado para los tubos Dichos pernosInstalar los soportes Instalar la unidad interiorDoblar tubos Procesamiento de abocardadoPara cableado trenzado Figura B Cableado de la unidad interior Ejecución de prueba Montar LA Placa DE LA Cubierta Y LA Rejilla DE EntradaPage Page Page Indice Conformità AI Regolamenti Europei PER I Modelli Smaltimento dell’imballo del nuovo condizionatore AttenzioneSmaltimento del vecchio condizionatore Istruzioni per la sicurezza e AvvisiAvviso Precauzioni di sicurezzaParti e funzioni Pericolo Telecomando  Installazione delle batterie Funzionamento Funzionamento di base Funzionamento power/quiet La- funzione Sleep Riposo non è disponibileSollevare i filtri dell’aria per rimuoverli Pulizia e manutenzioneSuggerimenti Pulire i filtri dellariaIl condizionatore non si avvia Risoluzione dei problemiFenomeni che seguono non indicano un problema Raffreddamento o riscaldamento mediocreRaffreddamento mediocre Unità interna lampeggiaCollegare il cavo di messa a terra Processo di installazioneElementi PER L’INSTALLAZIONE Collegamento dei cavi elettriciFigura Posteriore Destra Giù Installazione a Soffitto FiguraInstallazione delle staffe Figura 14ACollegare i cavi al blocco terminali Collegamento DEI Cavi ElettriciCavi solidi o di tipo F Figura a Rimuovere la scatola dei componenti elettrici Funzionamento di prova Page Page Page Table des matières Conformité DES Modèles LA Législation Européenne Mise au rebut de lemballage de votre nouveau climati- seur Mises en gardeMise au rebut de lancien climatiseur Consignes de sécurité et avertissementsPièces et fonctions Consignes de sécuritéRemarque  Télécommande  Installation des piles Utilisation Opération de base Réglage de lorientation du souffle dair Nettoyage et entretien Conseils dutilisationLe climatiseur ne se met pas en route DépannageCe qui suit nest pas à considérer comme des problèmes Refroidissement ou chauffage faibleRaisons Possibles Mauvais refroidissementCode DE Défaillance nom Dépannage Bre de clignotement du voyantAvertissement Procédure dinstallationSous le plafond Console au sol Installation du tuyau de vidange Installation AU Plafond Perçage pour les conduitsInstallation de lunité intérieure Installation des supportsNON Pour plier les tuyaux Raccordement DES Conduits 1. Procédure dévasementCâblage du type toron Fig.B Bornier de lunité intérieure Bornier de lunité extérieure Câblage de lunité extérieureInstallation DE LA PLAQUE-COUVERCLE ET DE LA Grille Dentrée Test de fonctionnementPage Page Page Inhalt Wichtige Informationen ZUM Verwendeten Kältemittel Entsorgung der Verpackung Ihrer neuen Klimaanlage SicherheitshinweiseEntsorgung der alten Klimaanlage Sicherheits-und WarnhinweiseTeile und Funktionen SicherheitsvorkehrungenHinweis  Fernbedienung  Einlegen der Batterien Bedienung  Grundbedienung Einstellen der Luftstromrichtung Reinigung und Pflege Hinweise zur BedienungKlimaanlage startet nicht Folgende Zustände sind keine ProblemeFehlerbehebung Es wird unzureichend gekühlt oder geheiztSchlechte Kühlleistung LED des InnengerätsInstallationsablauf Unter der Decke BodenkonsoleBohrloch für Rohrleitung HinweisBodenkonsolentyp Anbringen des AbflussschlauchsVorsicht DeckenmontagetypMontieren der Halterungen Installieren des InnengerätsNein Verbiegen von Rohren Anschluss DER RohrleitungRingverbindung Für Verdrahtung mit Einzeldrähten Abb. BVerdrahtung des Innengeräts Testlauf Montieren DER Abdeckplatte UND DER EinlassöffnungPage

AC12CS1ERA, AC24CS1ERA, AC18CS1ERA specifications

The Haier AC series, which includes the AC24CS1ERA, AC18CS1ERA, and AC12CS1ERA, stands out in the realm of air conditioning units for their blend of advanced technology and user-friendly features. Each model is designed to cater to a variety of room sizes and cooling needs, ensuring a comfortable indoor environment regardless of outdoor conditions.

The Haier AC24CS1ERA is a powerhouse, designed for larger spaces. With a cooling capacity of 2.0 tons, this model is equipped to efficiently cool sizable rooms while maintaining energy efficiency. The highlight of this model is its intelligent temperature control technology, which allows users to set their desired temperature quickly and accurately. The inverter technology enables smooth operation with minimal fluctuations in temperature. Additionally, it offers a quiet operation mode, perfect for bedrooms or study areas where noise can be a distraction.

The AC18CS1ERA is a mid-range option with a cooling capacity of 1.5 tons. It is ideal for medium-sized rooms, providing an optimal balance between performance and energy consumption. One of the standout features of this model is its multi-mode operation, which includes cooling, heating, dehumidifying, and fan modes. This versatility makes it suitable for year-round use, effectively coping with varying weather conditions. The inclusion of a user-friendly remote control enhances convenience, allowing adjustments from a distance.

For smaller spaces, the Haier AC12CS1ERA, with a cooling capacity of 1 ton, is an excellent choice. Its compact design makes it easy to install in rooms where space is limited. This model also incorporates eco-friendly refrigerants, aligning with growing environmental consciousness. The AC12CS1ERA features a sleek design that blends seamlessly with modern interiors while ensuring effective cooling performance. It also boasts easy maintenance features, such as a removable filter that can be easily cleaned to keep air quality high.

In terms of characteristics, all three models are equipped with high-efficiency compressors that optimize energy usage while delivering powerful cooling. Additionally, they come with advanced air filtration systems that help reduce dust and allergens, contributing to healthier indoor air quality. The sleek aesthetic of these units, combined with their robust functionality, illustrates Haier’s commitment to innovation and consumer satisfaction.

In summary, the Haier AC24CS1ERA, AC18CS1ERA, and AC12CS1ERA provide efficient cooling solutions tailored to different room sizes and needs. With intelligent features, energy-efficient technologies, and user-centric designs, these air conditioners are a top choice for consumers seeking reliable and stylish cooling options.
Top Page Image Contents