Dynaudio Air Series manual Digital Setup, Analog Setup

SETUPS

To set a Master monitor as System Controller the TC Link button on the rear panel MUST be in out-position.

5.1 Digital Setup

This illustration shows how to connect a 5.1 digital setup

•Left monitor is set as System Controller by leaving out the TC Link button on the rear panel.

•Left monitor receives both Left and Right Input signal. Right channel is fed via the TC -LINK RJ-45 connection from the Left to Right.

•LS monitor receives both Left and Right Surround channels. The RS channel is fed via the RJ-45 connection from LS to RS.

•Center monitor receives both Center and LFE channels. The LFE monitor is fed via the RJ-45 connection from Center to LFE.

•The Remote, AIR Soft and AIR PC-IP can be connected to any available TC LINK Out connection.

To set a Master monitor as System Controller the TC Link button on the rear panel MUST be in out-position.

5.1 Analog Setup

This illustration shows how to connect a 5.1 analog setup

•Left monitor is set as System Controller by leaving out the TC Link button on the rear panel.

•Left monitor receives both Left and Right Input signal. Right channel is fed via the TC -LINK RJ-45 connection from the Left to Right.

•LS monitor receives both Left and Right Surround channels. The RS channel is fed via the RJ-45 connection from LS to RS.

•Center monitor receives both Center and LFE channels. The LFE monitor is fed via the RJ-45 connection from Center to LFE.

•With no Bass-management active the Sub will play only the LFE channel.

•With Bass-management activated Low Frequency information from the 5 main channels is extracted and distributed to the Sub where it is summed with the LFE channel.

•The Remote, AIR Soft and AIR PC-IP can be connected to any available TC LINK Out connection.

The setups will ONLY operate correctly if connected according to the illustrations!

8