Dynaudio Air Series manual This illustration shows how to connect a 5.3 Digital setup

To set a Master monitor as System Controller the TC Link button on the rear panel MUST be in out-position.

To set a Master monitor as System Controller the TC Link button on the rear panel MUST be in out-position.

SETUPS

5.3 Digital Setup

This illustration shows how to connect a 5.3 Digital setup

• Center is set as System Controller by leaving out the TC Link button on the rear panel.

• Left monitor receives both Left and LS signal. The LS monitor is fed via the TC LINK RJ-45 connection form Left to LS.

• Center monitor receives both Center and LFE signal. The LFE monitor is fed via the TC LINK RJ-45 connection from Center to LFE.

• Right monitor receives both Right and RS signal. The RS monitor is fed via the TC LINK RJ-45 connection from Right to RS.

• With Bass-management “off” Left and Right Subs receives no signal.

• With Bass management “on”:

-Low frequency information from Left and LS is extracted and fed to Left Sub.

-Low frequency information from Right and RS is extracted and fed to Right Sub.

-Low frequency information from Center is extracted, summed with the LFE channel and fed to Center Sub.

•The Remote, AIR Soft and AIR PC-IP can be connected to any available TC LINK Out connection.

5.3 Analog Setup

This illustration shows how to connect a 5.3 Analog setup.

Please see description on 5.3 Digital Setup above regarding Bass-management but notice how to connect the Analog signals:

• Left channel to Left Input on the Left monitor.

• Left Surround channel to Right Input on the Left monitor.

• Center channel to the Left Input on the Center monitor.

•LFE channel to the Right Input on the Center monitor.

•Right channel to the Left Input on the Right monitor.

• Right Surround channel to Right Input on the Right monitor.

• The Remote, AIR Soft and AIR PC-IP can be connected to any available TC LINK Out connection.

The setups will ONLY operate correctly if connected according to the illustrations!

9