AIR SOFT
During Software upload various messages could be displayed:
Example:
In a 5.1 AIR setup you are uploading monitor software to the entire system. As there are separate software files for monitors and subs the following message should appear.
“5 AIR monitors updated successfully”
-meaning the AIR monitors are updated but no software has been accepted by the connected sub.
If a monitor lost connection during transfer it will not be indicated or counted, but the software upload continues.
If the message: “Failed to update AIR monitors” - is displayed, some of the monitors have reported an error during software upload. This could be caused by communication errors. Please retry.
OK
Press to exit screen and execute Autodetect command if marked.
Monitor assignment
Task
•Press monitor symbol to activate pink noise
•Then select task for the monitor now playing the noise. Serial number and type will be indicated.
A monitor marked with an exclamation mark indicates that an “unknown” monitor has been detected.
Scan System
Press the
Save Settings
All settings except “preset settings” are saved to a
Load Settings
Press and browse to select file to load.
Follow the instructions.
| Calibrate - Main Monitors |
System Setup |
Configuration
Select your current setup.
Analog Gain
Range: 9dBu, 15dBu, 21dBu or 27dBu
Set to match analog Input gain to match the signal fed to the optional Analog Input card.
BNC Input BNC Sync On:
The monitor attempts to lock on the Word Clock BNC.
Mute | Solo | Pink Noise |
Via the Calibrate screen, parameters and settings for the Main monitors are controlled.
The screen is accessed via the Main Screen by holding the cursor above the desired monitor and selecting the hammer icon.
Room position
Range: Neutral, Wall, Corner, Console, C. Wall or C. Corn Select according to the actual position of the monitor.
X Curve
Range: Off,
Two modifications of
49