Dynaudio Air Series Stereo Setup With Chains on L & R, Other Chained Setups, Analog/Digital setup

SETUPS

To set a Master monitor as System Controller the TC Link button on the rear panel MUST be in out-position.

Stereo Setup With Chains on L & R

This illustration shows how to connect a stereo setup with chains on Left and Right.

The chained monitors are fed with the same signal as the front L&R monitors. This the type of setup you would use when you wiish to be able to alternate between a set of main- and nearfiels -monitors.

•Left monitor is set as System Controller by leaving out the TC Link button on the rear panel.

•Left monitor receives both Left and Right Input signal.

•Right monitor receives audio via the TC-LINK RJ-45 connection.

•The Remote, AIR Soft and AIR PC-IP can be connected to any available TC LINK Out connection.

Other “Chained” Setups

From software 1.10 the available setups with “chain” option is: 5.1, 6.1 and 5.3 for analog and digital and well as 5.1/6 master (digital only).

The installed option card will limit the choises of setups presented on the speakers. If the AES/EBU option card is installed, the default digital Input will become Input 1 on the option card.

		•	Left Surround monitor receives both LS and RS signal.
			The RS monitor is fed via the TC LINK RJ-45 connection
To set a Master			from LS to RS.
monitor as		•	Left Inner monitor receives both L Inner and R Inner
System Controller			signal. The R Inner monitor is fed via the TC LINK RJ-45
the TC Link			connection from L Inner to R Inner.
button on the rear		•	With Bass-management activated Low Frequency
panel MUST be in
			information from the 5 main channels is extracted and
out-position.
			distributed to the Sub where it is summed with the LFE
			channel. With Bass-management enabled, Low
			Frequency information is not extracted for the Left and
			Right Inner monitors.
		•	The Remote, AIR Soft and AIR PC-IP can be connected
			to any available TC LINK Out connection.
		Analog connections
		•	Left channel to Left Input on Left monitor.
		•	Right channel to Right Input on Left monitor.
		•	Center channel to Left Input on Center monitor.
		•	LFE channel to Right Input on Center monitor.
7.1 Analog/Digital setup		•	Left Surround channel to Left Input on Left Surround
			monitor.
Digital		•	Right Surround channel to Right Input on Left Surround
•	Left is set as System Controller by leaving out the TC		monitor.
	Link button on the rear panel.	•	Left Inner channel to Left Input on Left Inner monitor.
•	Left monitor receives both the Left and Right signal. The	•	Right Inner channel to Right Input on Right Inner monitor.
	Right monitor is fed via the TC LINK RJ-45 connection
	form Left to Right.			It is not possible to choose a 7.1 setup in the setup
•	Center monitor receives both Center and LFE signal. The			menu; you need to choose either a 5.1 or 6.1
	LFE monitor is fed via the TC LINK RJ-45 connection			setup, and set up the Left Inner and Right Inner
	from Center to LFE.			speakers for ‘L Inner’ and ‘R Inner’ tasks respectively.

11