Ericsson LZT-1872R1A manual

Page 11

adjustments may result in illegal emissions, including off- frequency operation, or damage to the radio.

Should an UNLOCK condition be shown in the LCD display, or the LCD fails to display information, or all icons and display segments are shown, turn the ON/OFF/VOLUME control OFF then ON to reset the microprocessor. Ensure that the battery is fully charged and check that the antenna is securely tightened.

If the unit still fails to operate properly, refer to an Authorized Service Center for servicing.

11

Image 11

Contents Ericssonz Page Table of Contents Table of Contents con’t Conventional Mode Operation Safety Information Battery Charging and Care For Best Performance Extended Operations FCC Licensing Transceiver ServicePage This page intentionally left blank Introduction Page Features Quick Reference Guide Controls Page Mute SYS and GRP/CHANNEL Indicators IndicatorsBusy Status IndicatorsStandard Tones Alert TonesTones for Trunked Operation only Edacs Page Keypad Lock Error MessagesScat Operation Keypad MuteEdacs Operation Receiving a Message Page Sending a Message Squelch AdjustmentSending a Special Call Press and hold the SHIFT/CLR/MONITOR buttonPage Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual and Interconnect Numbers Page Seven digits of the telephone number will be displayed Dtmf Overdial ADD/DELETE Groups Scan Operation ENABLE/DISABLE ScanWide Area and Priority System Scanning Optional Delete GroupsDynamic Regrouping Optional Prosound OptionalEmergency Operation Optional HOME/EMERGENCY KEY DefinitionSending An Emergency Call Home Select GE-MARC Operation Receiving a MessageSending a Message Page SPC CAL Page Sending a PRE-PROGRAMMED Special Call in Conference Call Sending a Manually Entered Individual Call Page Sending a Manually Entered Interconnect Call Manually from the key pad, press thenumberkey Page Storing Individual and Interconnect Numbers Page Page Page GE-MARC Special Call Flowchart Wide Area System Scan Direct ModeReceiving a Message Sending a Manually Entered Interconnect Call Scan Operation Enable/Disable ScanScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message Sending a Manually Entered Interconnect Call Scan Operation Be removed from the scan list OPERATOR’S Radio Setup System TRK/CNV GRP/CHN Number Name USE Nickel Cadmium Battery Warranty Warranty Emergency Numbers