Ericsson LZT-1872R1A manual Edacs Operation Receiving a Message

Page 27

EDACS OPERATION

RECEIVING A MESSAGE

1.Turn the radio on by rotating the ON/OFF/VOLUME control clockwise from the OFF detent position. After the radio has passed the power-up self test an optional tone will sound and the current System and Group will be displayed. If the unit does not pass the test, an error message will be displayed (see ERROR MESSAGES section) or the display will be blank.

2.Press the SHIFT/CLR/MONITOR button and then use the SELECT buttons <or > to select an EDACS system. Press the SHIFT/CLR/MONITOR button to exit system select.

3.Use the SELECT buttons <or >to select the desired group. The GRP icon will indicate the current Group selected. The radio is now ready to receive messages.

4.INDIVIDUAL CALL - If an individual call (call directed only to your radio) is received, the radio unsquelches on the assigned channel. The BUSY flag lights. If programmed on, the individual call received tones (one high followed by one low) will sound and the originator’s ID or just “ID” (dependent upon programming) is displayed for a short time.

27

Image 27
Contents Ericssonz Page Table of Contents Table of Contents con’t Conventional Mode Operation Safety Information Battery Charging and Care For Best Performance Extended Operations FCC Licensing Transceiver ServicePage This page intentionally left blank Introduction Page Features Quick Reference Guide Controls Page Mute SYS and GRP/CHANNEL Indicators IndicatorsBusy Status IndicatorsStandard Tones Alert TonesTones for Trunked Operation only Edacs Page Keypad Lock Error MessagesScat Operation Keypad MuteEdacs Operation Receiving a Message Page Sending a Message Squelch AdjustmentSending a Special Call Press and hold the SHIFT/CLR/MONITOR buttonPage Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual and Interconnect Numbers Page Seven digits of the telephone number will be displayed Dtmf Overdial ADD/DELETE Groups Scan Operation ENABLE/DISABLE ScanWide Area and Priority System Scanning Optional Delete GroupsDynamic Regrouping Optional Prosound OptionalEmergency Operation Optional HOME/EMERGENCY KEY DefinitionSending An Emergency Call Home Select GE-MARC Operation Receiving a MessageSending a Message Page SPC CAL Page Sending a PRE-PROGRAMMED Special Call in Conference Call Sending a Manually Entered Individual Call Page Sending a Manually Entered Interconnect Call Manually from the key pad, press thenumberkey Page Storing Individual and Interconnect Numbers Page Page Page GE-MARC Special Call Flowchart Wide Area System Scan Direct ModeReceiving a Message Sending a Manually Entered Interconnect Call Scan Operation Enable/Disable ScanScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message Sending a Manually Entered Interconnect Call Scan Operation Be removed from the scan list OPERATOR’S Radio Setup System TRK/CNV GRP/CHN Number Name USE Nickel Cadmium Battery Warranty Warranty Emergency Numbers