Ericsson LZT-1872R1A manual For Best Performance

Page 8

be charged 14 to 16 hours on the first charge cycle and then in accordance with the charger model instructions thereafter.

To remove the battery pack, push up on the battery latch and slide the battery pack to the right. To replace the battery, align the battery on the track and slide to the left until a click is heard, indicating the battery is correctly installed.

If the battery is to be charged on the radio, ensure that the power switch on the radio is in the off position before charging. Failing to turn the power switch to off during the charge cycle will result in a less than full charge condition, which will noticeably reduce the operating time between charges!

Normal battery operation time is 8 hours. This may vary depending upon how much the receiver audio is present and how much you transmit. The actual time may vary from day to day depending upon operational requirements.

FOR BEST PERFORMANCE

1.Charge battery to full capacity, 14 hours at the standard C/10 rate (capacity X .10). For "rapid" chargers, allow additional time (2-3 hours) for "topping off" the charge after it switches from "fast" to "slow".

2.Use the battery soon and use as much of the battery capacity as possible or practical. A battery that is charged and discharged completely will maintain the

8

Image 8

Contents Ericssonz Page Table of Contents Table of Contents con’t Conventional Mode Operation Safety Information Battery Charging and Care For Best Performance Extended Operations Transceiver Service FCC LicensingPage This page intentionally left blank Introduction Page Features Quick Reference Guide Controls Page Mute Indicators SYS and GRP/CHANNEL IndicatorsStatus Indicators BusyAlert Tones Standard TonesTones for Trunked Operation only Edacs Page Error Messages Keypad LockKeypad Mute Scat OperationEdacs Operation Receiving a Message Page Squelch Adjustment Sending a MessagePress and hold the SHIFT/CLR/MONITOR button Sending a Special CallPage Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual and Interconnect Numbers Page Seven digits of the telephone number will be displayed Dtmf Overdial Scan Operation ENABLE/DISABLE Scan ADD/DELETE GroupsDelete Groups Wide Area and Priority System Scanning OptionalProsound Optional Dynamic Regrouping OptionalHOME/EMERGENCY KEY Definition Emergency Operation OptionalSending An Emergency Call Home GE-MARC Operation Receiving a Message SelectSending a Message Page SPC CAL Page Sending a PRE-PROGRAMMED Special Call in Conference Call Sending a Manually Entered Individual Call Page Sending a Manually Entered Interconnect Call Manually from the key pad, press thenumberkey Page Storing Individual and Interconnect Numbers Page Page Page GE-MARC Special Call Flowchart Direct Mode Wide Area System ScanReceiving a Message Sending a Manually Entered Interconnect Call Enable/Disable Scan Scan OperationScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message Sending a Manually Entered Interconnect Call Scan Operation Be removed from the scan list OPERATOR’S Radio Setup System TRK/CNV GRP/CHN Number Name USE Nickel Cadmium Battery Warranty Warranty Emergency Numbers