Ericsson LZT-1872R1A manual Status Indicators, Busy

Page 20

STATUS INDICATORS

BUSY	The Channel Busy flag is on when
	the radio receives a call or when a
	conventional channel is in use. The
	flag is also on when transmitting on a
	trunked channel.

BThe Battery flag is on when the battery power is low and needs charging.

SCAN	The SCAN flag is on when Scan is
	activated.

LOCK

V

PHONE

P

The LOCK flag is on when the keypad lock function is active.

The 8flag is used to indicate when a trunked group or conventional channel is scan enabled.

In EDACS or GE-MARC, the PHONE and 2status flags will be illuminated when the radio is placed in the Special Call mode.

CALL	The CALL flag will be illuminated
	when the radio receives an individual
	call in EDACS or GE-MARC modes.

Q

Monitor

Indicates that the “key press” tones are heard.

Indicates that the monitor mode has been enabled in a conventional

20

Image 20

Contents Ericssonz Page Table of Contents Table of Contents con’t Conventional Mode Operation Safety Information Battery Charging and Care For Best Performance Extended Operations Transceiver Service FCC LicensingPage This page intentionally left blank Introduction Page Features Quick Reference Guide Controls Page Mute Indicators SYS and GRP/CHANNEL IndicatorsStatus Indicators BusyAlert Tones Standard TonesTones for Trunked Operation only Edacs Page Error Messages Keypad LockKeypad Mute Scat OperationEdacs Operation Receiving a Message Page Squelch Adjustment Sending a MessagePress and hold the SHIFT/CLR/MONITOR button Sending a Special CallPage Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual and Interconnect Numbers Page Seven digits of the telephone number will be displayed Dtmf Overdial Scan Operation ENABLE/DISABLE Scan ADD/DELETE GroupsDelete Groups Wide Area and Priority System Scanning OptionalProsound Optional Dynamic Regrouping OptionalHOME/EMERGENCY KEY Definition Emergency Operation OptionalSending An Emergency Call Home GE-MARC Operation Receiving a Message SelectSending a Message Page SPC CAL Page Sending a PRE-PROGRAMMED Special Call in Conference Call Sending a Manually Entered Individual Call Page Sending a Manually Entered Interconnect Call Manually from the key pad, press thenumberkey Page Storing Individual and Interconnect Numbers Page Page Page GE-MARC Special Call Flowchart Direct Mode Wide Area System ScanReceiving a Message Sending a Manually Entered Interconnect Call Enable/Disable Scan Scan OperationScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message Sending a Manually Entered Interconnect Call Scan Operation Be removed from the scan list OPERATOR’S Radio Setup System TRK/CNV GRP/CHN Number Name USE Nickel Cadmium Battery Warranty Warranty Emergency Numbers