Ericsson LZT-1872R1A manual Storing Individual and Interconnect Numbers

Page 56

STORING INDIVIDUAL AND INTERCONNECT NUMBERS

1.Press the 5key to put the radio into Special Call mode. or %to put the radio into Conference Call mode. The radio displays the last accessed call number from the preprogrammed Special Call selection. The PHONE and 2flags will also be displayed. If no Special Calls are programmed the radio displays SPC CAL.

2.Enter the tone set (individual call) or telephone number to be stored. The last digit entered will always be displayed in the far right hand side of the display. Any previously entered digits will scroll left. Only seven digits will be visible at a time with the leading digit scrolling off the display upon each new Ikey entry. To backspace and clear a digit, press the

key.

NOTE

To recall the last interconnect number entered manually from the key pad, press the Hkey.

56

Image 56

Contents Ericssonz Page Table of Contents Table of Contents con’t Conventional Mode Operation Safety Information Battery Charging and Care For Best Performance Extended Operations Transceiver Service FCC LicensingPage This page intentionally left blank Introduction Page Features Quick Reference Guide Controls Page Mute Indicators SYS and GRP/CHANNEL IndicatorsStatus Indicators BusyAlert Tones Standard TonesTones for Trunked Operation only Edacs Page Error Messages Keypad LockKeypad Mute Scat OperationEdacs Operation Receiving a Message Page Squelch Adjustment Sending a MessagePress and hold the SHIFT/CLR/MONITOR button Sending a Special CallPage Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual and Interconnect Numbers Page Seven digits of the telephone number will be displayed Dtmf Overdial Scan Operation ENABLE/DISABLE Scan ADD/DELETE GroupsDelete Groups Wide Area and Priority System Scanning OptionalProsound Optional Dynamic Regrouping OptionalHOME/EMERGENCY KEY Definition Emergency Operation OptionalSending An Emergency Call Home GE-MARC Operation Receiving a Message SelectSending a Message Page SPC CAL Page Sending a PRE-PROGRAMMED Special Call in Conference Call Sending a Manually Entered Individual Call Page Sending a Manually Entered Interconnect Call Manually from the key pad, press thenumberkey Page Storing Individual and Interconnect Numbers Page Page Page GE-MARC Special Call Flowchart Direct Mode Wide Area System ScanReceiving a Message Sending a Manually Entered Interconnect Call Enable/Disable Scan Scan OperationScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message Sending a Manually Entered Interconnect Call Scan Operation Be removed from the scan list OPERATOR’S Radio Setup System TRK/CNV GRP/CHN Number Name USE Nickel Cadmium Battery Warranty Warranty Emergency Numbers