Ericsson LZT-1872R1A manual Sending a Message

Page 68

4.Press the SHIFT/CLR/MONITOR button twice ("double click") and hold to disable squelch and monitor the channel. Adjust the VOLUME contract to the desired audio level.

5.When a message is received (and the correct Channel Guard signal is decoded, if programmed and enabled) the receiver will unsquelch and the message will be heard.

SENDING A MESSAGE

1Turn the radio on and set the desired System and Channel as described in the previous section.

2.Ensure no one is transmitting on the selected channel by pressing the SHIFT/CLR/MONITOR button twice (“double click”) and hold and/or observing the display for the absence of the BUSY indicator to ensure that no one is transmitting on the selected Channel.

3.Holding the radio about 3 inches from your mouth, press the PTT bar and speak as you would normally into the microphone.

4.Release the PTT bar when the transmission is complete and listen for any reply.

SQUELCH ADJUSTMENT

In normal operation the squelch is automatically set by the radio and does not need adjusting. If it becomes

68

Image 68

Contents Ericssonz Page Table of Contents Table of Contents con’t Conventional Mode Operation Safety Information Battery Charging and Care For Best Performance Extended Operations Transceiver Service FCC LicensingPage This page intentionally left blank Introduction Page Features Quick Reference Guide Controls Page Mute Indicators SYS and GRP/CHANNEL IndicatorsStatus Indicators BusyAlert Tones Standard TonesTones for Trunked Operation only Edacs Page Error Messages Keypad LockKeypad Mute Scat OperationEdacs Operation Receiving a Message Page Squelch Adjustment Sending a MessagePress and hold the SHIFT/CLR/MONITOR button Sending a Special CallPage Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual and Interconnect Numbers Page Seven digits of the telephone number will be displayed Dtmf Overdial Scan Operation ENABLE/DISABLE Scan ADD/DELETE GroupsDelete Groups Wide Area and Priority System Scanning OptionalProsound Optional Dynamic Regrouping OptionalHOME/EMERGENCY KEY Definition Emergency Operation OptionalSending An Emergency Call Home GE-MARC Operation Receiving a Message SelectSending a Message Page SPC CAL Page Sending a PRE-PROGRAMMED Special Call in Conference Call Sending a Manually Entered Individual Call Page Sending a Manually Entered Interconnect Call Manually from the key pad, press thenumberkey Page Storing Individual and Interconnect Numbers Page Page Page GE-MARC Special Call Flowchart Direct Mode Wide Area System ScanReceiving a Message Sending a Manually Entered Interconnect Call Enable/Disable Scan Scan OperationScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message Sending a Manually Entered Interconnect Call Scan Operation Be removed from the scan list OPERATOR’S Radio Setup System TRK/CNV GRP/CHN Number Name USE Nickel Cadmium Battery Warranty Warranty Emergency Numbers