Ericsson LZT-1872R1A manual Receiving a Message

Page 62

Receiving A Message

1.Press the SHIFT/CLR/MONITOR button and then use the SELECT buttons<or >to select a Direct Mode System. The SYStem display will indicated the current System selected.

2. Use the SELect buttons or >to select the desired Channel. The radio is now ready to receive message.

3.Press the SHIFT/CLR/MONITOR button twice (“double click”) and hold to disable squelch and monitor the channel. Adjust the VOLUME control to the desired audio level.

NOTE

Pressing the SHIFT/CLR/MONITOR twice (“double click”) to monitor the channel may affect Busy Tone signalling if programmed for the select channel.

4.When a message is received (and the correct Busy Tone signal is decoded, if programmed and enabled) the receiver will unsquelch and the message will be heard.

Sending A Message

1.Turn the radio on and set the desired System and Channel as described in the previous section.

62

Image 62

Contents Ericssonz Page Table of Contents Table of Contents con’t Conventional Mode Operation Safety Information Battery Charging and Care For Best Performance Extended Operations Transceiver Service FCC LicensingPage This page intentionally left blank Introduction Page Features Quick Reference Guide Controls Page Mute Indicators SYS and GRP/CHANNEL IndicatorsStatus Indicators BusyAlert Tones Standard TonesTones for Trunked Operation only Edacs Page Error Messages Keypad LockKeypad Mute Scat OperationEdacs Operation Receiving a Message Page Squelch Adjustment Sending a MessagePress and hold the SHIFT/CLR/MONITOR button Sending a Special CallPage Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual and Interconnect Numbers Page Seven digits of the telephone number will be displayed Dtmf Overdial Scan Operation ENABLE/DISABLE Scan ADD/DELETE GroupsDelete Groups Wide Area and Priority System Scanning OptionalProsound Optional Dynamic Regrouping OptionalHOME/EMERGENCY KEY Definition Emergency Operation OptionalSending An Emergency Call Home GE-MARC Operation Receiving a Message SelectSending a Message Page SPC CAL Page Sending a PRE-PROGRAMMED Special Call in Conference Call Sending a Manually Entered Individual Call Page Sending a Manually Entered Interconnect Call Manually from the key pad, press thenumberkey Page Storing Individual and Interconnect Numbers Page Page Page GE-MARC Special Call Flowchart Direct Mode Wide Area System ScanReceiving a Message Sending a Manually Entered Interconnect Call Enable/Disable Scan Scan OperationScan must be disabled to add a channel to the scan list This page intentionally left blank Conventional Mode Operation Sending a Message Sending a Manually Entered Interconnect Call Scan Operation Be removed from the scan list OPERATOR’S Radio Setup System TRK/CNV GRP/CHN Number Name USE Nickel Cadmium Battery Warranty Warranty Emergency Numbers